Mitsubishi Electric Super Helicross Series Instruction Manual page 16

４）Brake gap adjustment
a)W type (IP65)
a-1) Structure and operation
The figure below shows the structure of the brake. The standard and the shaft seal structure are different.
7
1
2
3
4
5
a-2) Resolution and assembly
The resolution and the assembly when the brake gap is adjusted are the same to standard points. Part only for the
waterproof type are installed and note the following point.
【Resolution】
Refer to the attached paper manual for the gap adjustment points.
Detach the Fan cover and the Fan. Loose the pan small screw. And detach the Brake cover together with Drainer
【Assembly】
Water proof connector and Seal support.
It is confirmed that Spacer is installed in the shaft and after installing the brake cover, push the Rotation board at
Spacer.
When starting and stopping,
spread grease on
End-face V seal
b) P type (IP67)
b-1) The brake is stored in the brake cover.
Execute it after detaching the bolt and the brake cover when the brake gap adjustment is necessary.
b-2) After adjusting the brake gap, paint the seal medicine (Three Bond® # 1211 etc.) on seal side of the brake of the
cover and the bracket.
５）Others
a) It asks for the maintenance of the output shaft and the output shaft oil seal and motor axis part at our factory or our
service center.
b) Please confirm there is not loosening in Capcon in the periodical inspection.
6 8
sound might be generated.(There is no problem on the function. Please
End-face V seal
.)
１
Item
２
３
４
５
６
７
８
※ Three Bond is a registered trademark of ThreeBond Holdings Co.,Ltd.
－ 14 －
Name of articles
Drainer Water proof connector
Spacer
End-face V seal
Seal support
Pan small screw
Brake cover
Fan
Fan cover