Table of Contents
Advertisement
SERVICE & INSTALLATION MANUAL - Emblem
www.cafection.com
7.7.3
Waste Bin
Frequency: daily or every 40 cycles
After each coffee cycle, the spent
grounds and used filter paper are
automatically discarded into the
waste bin. To prevent the bin from
overflowing, an automatic function
disables coffee-based beverages and
displays a message on the screen.
Default setting = 40
Maximum setting = 400
Minimum setting = 0
When using the internal waste bin provided with the unit, Cafection recommends
setting the counter to a maximum of 40 cycles using standard 8, 10 and 12 oz cups.
If the setting is too high, the wasted filter paper could jam in the brew group and
damages may occur.
Setting the maximum counter to zero (0) disables the automatic function and may
cause an overflow issue if the waste bin is full.
The equipment will not dispense coffee beverages until the bin is emptied and the counter
is resetted. The counter settings can be adjusted in accordance to the size of the waste
bin in the Settings sub tab, under the System tab in Service mode (see section 6.6.1).
How to empty the cabinet's waste bin
1. Open the cabinet's door, below the brewer.
2. Open the brewer's door and remove the front panel.
3. Cut the filter paper 4" below the brew group with scissors or tear gently. DO NOT
4. Remove the filled garbage bag from the waste bin and replace it with a new one.
5. Reinstall the front panel and close the doors.
6. Access Service mode and press the "Reset Waste Bin" button.
How to empty the brewer's internal waste bin
1. Open the brewer's door.
2. Take off the front panel.
3. Cut the filter paper 4" below the brew group with scissors or tear gently. DO NOT
4. Disengage the spout so there is room to pull the waste bin out of the machine.
5. Remove the internal waste bin, empty it and replace it inside the machine.
6. Reinstall the front panel and the spout, then close the door.
7. Access Service mode and press the "Reset Waste Bin" button.
It is very important not to yank on the filter paper. Doing so may result in a
malfunction of the machine.
DE2112INSA
Rev. 0 2022-01
800-561-6162
YANK ON THE PAPER!
YANK ON THE PAPER!
57
Advertisement
Table of Contents
Need help?
Do you have a question about the EMBLEM and is the answer not in the manual?
Questions and answers
Procedure to adjust cup size 10 oz only fills about 6 oz
To adjust the cup size on a Cafection EMBLEM to fill 10 oz, modify the amount of water in the beverage settings. Access the Service mode, navigate to the Recipes tab, and adjust the water quantity for the selected beverage to achieve a 10 oz fill. Save the changes before exiting.
This answer is automatically generated