vita Belham Living Craftsman Arbor Assembly Instructions Manual

A S S E M B LY I N S T R U C T I O N S
Belham Living Craftsman Arbor
Please read through before starting assembly.
IMPORTANT: CHECK THE INSIDE OF YOUR POSTS FOR ALL MATERIALS.

Check Box for These Contents

In the event of missing or defective parts please call our customer service dept. at 1 800 282 9346 (Mon. to Fri. 8:00 AM to 4:00 PM EST).
1. Posts (4) - 3" x 3" x 78" - 10221
2. Beams (2) - 3 1/2" x 3 1/2'" x 33 1/4" - 10222
3. Rafters (3) - 1 1/2" x 4 1/2" x 61" - 10223
4. Joists (5) - .875" x 3" x 34" - 10224
5. Rafter Decorative End Caps (6) - 10770-1
6. Temporary Ground Stakes (4) - 1 3/4" x 1 3/4" x 18" - 10225
7. 1 1/2 in Stainless Steel Screws (24) - 20005
8. 3 in Stainless Steel Screws (21) - 20007
9. Tube of Vinyl Glue (1) - 20000
Material You Will Need (Not Included;
for a permanent installation):
• 2 x 4 x 8 ft Pressure Treated Lumber (1) - Cut and ripped in
half to get four, 2 x 2 x 4 ft pieces.
• 2 Bags of Concrete Mix (if setting arbor in concrete footings)

Tools You Will Need

• Hammer
• Tape Measure
• Level
• Stool or Short Ladder
• Shovel or Auger
• Cordless Drill

General Information

• Read Instructions through carefully before beginning assembly.
• When assembling components, place on a non-abrasive surface
(i.e. shipping box) to avoid scratching.
• We recommend an area approx 10'x 8' for unobstructed assembling.
• You should not need to use excessive force when assembling components.
75 1/4 in
75 5/8 in
48 in
54 in
4
5
2
1
3
6 7 8 9
(Not to scale)
34 1/8 in
82 1/8 in
20 in
26 in
V2.3/DEC2320
1