Table of Contents
Advertisement
MAINTENANCE PROCEDURES
6. Unscrew drain plug and discard
the gasket ring.
1. Gasket ring (discard)
2. Drain plug
7. Allow oil to drain completely from
the crankcase.
8. Clean the drain plug.
9. Install a NEW gasket ring on the
drain plug.
N N O O T T I I C C E E
N N e e v v e e r r u u s s e e t t h h e e g g a a s s k k e e t t r r i i n n g g a a s s e e c c - -
o o n n d d t t i i m m e e . . A A l l w w a a y y s s r r e e p p l l a a c c e e b b y y a a
n n e e w w o o n n e e . .
10. Install and tighten drain plug to the
recommended specification.
T T i i g g h h t t e e n n i i n n g g T T o o r r q q u u e e
Drain plug
11. Replace oil filter. Refer to Oil Filter .
12. Refill engine, refer to Recom-
mended Engine Oil .
N N O O T T E E : : For engine oil capacity, refer
to Technical Specifications .
13. Start engine and let it idle for a 60
seconds.
14. Stop engine.
15. Check the oil level immediately, re-
fer to Verifying the Engine Oil
Level .
16. Refill as necessary.
17. Ensure oil filter and drain plug
areas are not leaking.
136
30 ± 2 Nm
(22 ± 1 lbf-ft)
18. Dispose oil and filter as per your
local environmental regulations.
T T w w i i n n C C y y l l i i n n d d e e r r s s E E n n g g i i n n e e s s
V V e e r r i i f f y y i i n n g g t t h h e e E E n n g g i i n n e e O O i i l l L L e e v v e e l l
( ( V V - - T T w w i i n n ) )
N N O O T T I I C C E E
O O p p e e r r a a t t i i n n g g t t h h e e e e n n g g i i n n e e w w i i t t h h a a n n i i m m - -
p p r r o o p p e e r r l l e e v v e e l l m m a a y y s s e e v v e e r r e e l l y y d d a a m m - -
a a g g e e e e n n g g i i n n e e . .
N N O O T T I I C C E E
C C h h e e c c k k t t h h e e o o i i l l l l e e v v e e l l w w h h e e n n t t h h e e e e n n - -
g g i i n n e e i i s s c c o o l l d d . .
1. Place vehicle on a level surface.
2. Clean around dipstick to avoid for-
eign particles falling down the
tube.
3. Unscrew dipstick then remove it
and wipe clean.
4. Reinstall dipstick, screw in it
completely.
5. Remove dipstick and check oil lev-
el. It should be near or equal to the
upper mark.
1. MIN
2. MAX
If the level is between marks, rein-
stall the dipstick.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Can-Am Defender 2022 Series and is the answer not in the manual?
Questions and answers
How does the cargo bed open?
The cargo bed on a BRP Can-Am Defender 2022 Series opens using a tailgate. To open it, you need to lower the tailgate by releasing the retaining cables. When closing, always secure the tailgate before operating to prevent load loss.
This answer is automatically generated