Starting Procedures; Starting Procedures, Trucks With Key Switch - Yale Veracitor GCC040VX Operating Manual

If the truck is locked out, the message PASSWORD LOCK-
OUT, SUPERVISOR REQUIRED is displayed. A Lockout
Reset, Supervisor, or Service password is needed to unlock
the lift truck. System power can be turned OFF, while in lock-
out mode by turning key switch to OFF or pressing the Power
ON/OFF button. To reset a system lockout that occurs while
attempting to enter a password within the on-board menu,
after a correct operator password has been entered, recycle
the system power. For all other lockout conditions, cycling
the truck power will not reset the lockout.

Starting Procedures

Do not start or operate the lift truck, includ-
ing any of its functions or attachments, from
any place other than the designated oper-
ator's position.
If equipped, be sure cab door is secured in
the closed position or removed before start-
ing lift truck operations.
If lift truck is equipped with the optional operator presence
system, the following sequence must be followed for engine
to start:
• Operator must be in seat
• Seat belt must be fastened
• Make sure park brake is applied

Starting Procedures, Trucks With Key Switch

WARNING
LPG is very flammable. An odor of LPG fuel can indicate
a leak in the fuel system. DO NOT start the engine until
the fuel leak is repaired and the atmosphere is free of
LPG.
WARNING
Gasoline is extremely flammable. Do not start the engine
if a gas leak is detected.
1. If the lift truck uses LPG fuel, open the fuel valve on the
LPG tank.
NOTE: The warm-up/thaw cycle can be bypassed at anytime
by cranking the engine normally.
2. Turn/push the key switch to the ON position but do not
crank the engine.
Operating Procedures
67