Advertisement
4. PREPARATION
WARNING: Before fitting the battery and attempting to start the motor ensure that, if fitted, the blade (fig.1) is correctly mounted.
‰
4.1.
FIT BATTERY
4.2.
BATTERY CHARGE STATUS TEST
4.2.1.
Press trigger, all LEDs lit: battery charged, one LED (orange) lit: battery needs charging (3 LEDs orange / yellow / green).
4.3.
In order to maintain battery efficiency: DO NOT fully discharge. After every use fully charge the battery, charge every 4 months
even if tool is not used. If a decrease of performance of the tool is noticed, charge the battery.
5. OPERATION
5.1.
Ensure that you have read, understood and comply with
all the safety instructions in Section 1.
5.2.
FITTING BLADE
WARNING: Remove battery before fitting blade or
‰
maintenance is carried out.
5.2.1.
To remove the blade rotate Blade Release Collet (fig.1)
and withdraw the blade from the Collet. The Collet
will spring closed when released.
5.2.2.
To insert a replacement blade, rotate Blade Release
Collet (fig.1) and insert the blade into the Collet.The
Collet will spring closed when released.
5.3.
WORK CLAMP
5.3.1.
To remove the Work Clamp, depress the Clamp Release
Lever (fig.1) and withdraw the Clamp from the saw body.
5.3.2.
To replace the Work Clamp, depress the Clamp Release
Lever (fig.1) and insert the Clamp tab into the saw body.
5.4.
CUTTING
5.4.1.
Ensure you have fitted the correct blade for the material
to be cut.
DO NOT switch the saw on whilst the blade is in contact
8
with the workpiece.
5.4.2.
Hold the power tool by insulated gripping surfaces when
performing an operation where the cutting accessory may
contact hidden wiring or its own cord.
5.4.3.
Use clamps or another practical way to secure and
support the workpiece to a stable platform.
5.4.4.
Depress the Trigger Lock (fig.2) in either direction and
gently squeeze the Trigger (fig.2).
NOTE:
To stop the motor, release the Trigger. The Trigger Lock
will automatically re-engage.
6. MAINTENANCE
WARNING! Remove battery from tool before performing
‰
any maintenance or making adjustments.
6.1.
Remove dust with a soft bristled brush.
DO NOT use solvents clean with a soft damp cloth.
8
DO NOT use compressed air (risk of ejection).
8
6.2.
Professional repair only, contact authorised service centre.
6.3.
STORAGE: Store in a child free,dry location.
© Jack Sealey Limited
Work Clamp Release Lever
fig.1
Work Clamp
fig.2
Original Language Version
Blade Release Collet
Battery Level LEDs
Trigger
CP108VRSBO Issue:1 19/04/21
Trigger Lock
Advertisement
