Welcome... to your Armorgard TrekDror, the safest and most secure tool drawer range for your vehicle. The TrekDror comes ready to use, but please consult this manual for instructions on how to adapt it to your needs. Please read this user manual carefully...
If you decide to fit the TrekDror in a vehicle, consult the vehicle manufacturer before carrying out any work to the vehicle itself. Armorgard cannot be held responsible for any damage caused while fitting the TrekDror unit. When stacking TrekDrors, 4 brackets must be used to fully support the units.
Removing and fitting the drawer To remove the drawer, pull it right Locate the two bolts inside the out until it stops. drawer at the rear. Loosen these bolts off, until the The drawer can now be removed. drawer can slide out freely. When it is replaced, ensure that the bolts are tightened up again and test to ensure the drawer...
Mounting the TrekDror using the fixing points Remove the drawer and slot two At the front, push the bolts coachbolts into the fixing points at through from inside the casing. the rear of the casing. Drop the M10 bolts are recommended for rear down through prepared holes best fit.
Please call 023 9238 0280 for more details. General Information Lost Keys? Replacement keys can be purchased from Armorgard, using the serial number on the product. Spare Parts The following parts are available to order separately:...
Page 7
View our full range of products online at www.armorgard.co.uk...
Page 8
Unit 14-16, Standard Way, Fareham Industrial Park, Fareham, Hampshire PO16 8XB t: 023 9238 0280 e: sales@a-sp.co.uk w: www.armorgard.co.uk...
Need help?
Do you have a question about the TrekDror TKD1 and is the answer not in the manual?
Questions and answers