Table of Contents
Advertisement
Installation
Water inlet installation
Tap selection
The front end should be longer than 10mm.
The tap exit end face should be flat and smooth, if not file it to avoid leakage.
Suitable tap
C
o
n
n
e
t c
h t
i e
l n
1. Press down the slider and remove the inlet hose connector from the inlet hose ,
like below illustration 1.
2. Loosen the four bolts on the inlet hose connector till the tap can be accessed, then
set the inlet hose connector in the tap, see illustration 2.(if the tap caliber is too large and
could not set the inlet hose end, unscrew the four bolts and take out the bushing, tap exit
end must be flat, otherwise it will leak, see illustration 3)
Inlet hose
Illustration 1
3. Fasten the four bolts on the inlet hose connector evenly, see illustration 4.
4. Twist the nut as the illustration, see illustration 5.
Note: Before twisting the nut, the threading is about 4mm above the upper surface of the nut, after twisting,
the threading is less than 2mm above the upper surface of the nut, see illustration 6.
Illustration 4
t e
h
o
s
e
c
o
n
n
e
t c
r o
Inlet hose connector
Slider
Illustration 2
Illustration 5
Not suitable tap
o t
h t
e
a t
p
Bolt
Screwdriver
Nut
14
Bushing
Illustration3
Before twisting,about 4mm
After twisting,less 2mm
Illustration 6
Advertisement
Table of Contents
