Figure 11 Power Switch Location On The Nokia 50I - Nokia 50i Installation Manual

Figure 11 Power Switch Location on the Nokia 50i

To connect the power
1. Connect the power cord securely into the power plug on the back of the
2. Plug the other end of the cord into a three-wire grounded power strip or
3. Press the power supply switch to the On position to provide power.
Check the power LED on the front panel of the gateway (the Nokia logo) to
ensure that the power supply is operating correctly. The power LED should be
illuminated.
If the power LED is not illuminated:
!
!
!
If the power LED does not illuminate, contact your Nokia service provider as
listed in
Nokia 50i Installation Guide
gateway.
wall outlet.
Check the power supply cord to make sure it is properly connected.
Make sure the power supply switch is on.
Make sure that power is turned on to the power strip or wall receptacle
that you plugged the gateway in to.
"Nokia Contact Information"
Performing the Initial Hardware Configuration
Power plug
on page 3 for technical support.
00321
Power switch
37