Panasonic KX-HNC600C Installation Manual page 21

5
Attach the safety wire to the wall.
R Place the ring of the safety wire (A)
on the wall.
R Place the washer (B) on top of the
ring of the safety wire.
R Tighten the screw (C) for the safety
wire on top of the washer.
3
Note:
R Attach the safety wire while it is bent.
R Attach the safety wire high on the wall
so that the camera does not strike
anyone in the event the camera
detaches from the wall.
R Do not hang from the camera or stand.
For assistance, visit www.panasonic.ca/english/support
HNC600C_(en_en)_0113_ver.201.pdf
6
1
2
Note about power connections
AC adaptor connection
R The AC adaptor must remain connected at
R The AC adaptor should be connected to a
Power failure
R The camera will not work during a power
21
Connect the DC cable to the AC adaptor.
R Pull the DC cable indoors, and connect
the DC cable plug (A) to the AC
adaptor plug (B).
R Connect the AC adaptor (C) to the
power outlet.
Outdoors
1
Indoors
2
1
Note:
R Use only the supplied Panasonic AC
adaptor PNLV236.
R Be sure to connect the DC cable plug
and AC adaptor plug indoors.
all times. (It is normal for the adaptor to feel
warm during use.)
vertically oriented or floor-mounted AC
outlet. Do not connect the AC adaptor to a
ceiling-mounted AC outlet, as the weight of
the adaptor may cause it to become
disconnected.
failure.
Setup
2
1 2
3
21
2017/01/13 11:54:14