Table of Contents
Advertisement
Installing the Transom-Mount Bracket
If you are mounting the bracket on fiberglass with screws, it is recommended to use a countersink bit to drill a
clearance counterbore through only the top gel-coat layer. This will help to avoid cracking in the gel-coat layer
when the screws are tightened.
1 Place the included template in the selected mounting location on the transom.
5
2 Using a 4 mm (
/
in.) bit, drill pilot holes in the middle of the adjustable mounting holes on the template.
32
NOTE: You can wrap a piece of tape around the bit 19 mm (
holes too deep.
3 Remove the template from the mounting surface.
4 Place the spray guard
5 Apply marine sealant to the included 20 mm screws.
6 Using the five 20 mm screws
When installing this bracket, be sure to install screws all five mounting holes. This is especially important on
vessels that operate at high speeds. If screws are not installed in all of the mounting holes, the bracket may
bend or break when the vessel moves at high speeds, dislodging the transducer.
NOTICE
against the back of the transom-mount bracket
, loosely attach the transducer mount and spray guard to the transom.
7
/
in.) from the point to avoid drilling the pilot
10
NOTICE
so the mounting holes align.
3
Advertisement
Table of Contents
Need help?
Do you have a question about the LIVESCOPE PLUS LVS34 and is the answer not in the manual?
Questions and answers