Base Features; Basic Base Station Features - EnGenius FreeStyl SIP User Manual

Basic Base Station Features

1. Antenna
a. The antenna port has a reversed thread connector; to remove antenna or
cable, turn clockwise; to install, turn counterclockwise. Improper
installation may damage the connector.
b. When using an outdoor antenna, locate the antenna (not the base station
itself) as high as possible for a clear transmission path.
2. LED
a. Power /Standby (blue color): indicates base station has power.
b. In-Use (blue color): indicates an active SIP call.
c. Registration (white color): indicates base in registration mode.
d. Page (white slow blinking): indicates base is paging handset.
e. Inbound call (white fast blinking): indicates an inbound call is ringing.
3. RESET Button
a. Restores base station to factory settings
b. Reset button is intended to prevent accidental system reset.
c. All handsets (including administrator) need to be re-registered after a base
station reset.
4. Page Button (Locate handset)
To find a misplaced handset; press "PAGE" and all registered handsets will beep
for 30 seconds.
Press "PAGE" again or any key on handset to stop.
Re: "PAGE" is for locating handset only, not able to make intercom with
handset.
5. Registration Button (PAGE)
Enters registration mode along with handset, assigns handset ID (10-19).
6. LAN Jack
Standard RJ-45 connector to plug in the Ethernet(LAN) line
7. DC In: to plug in the power adaptor

Base Features

~25~