Related Manuals for Leggett & Platt Adjustable Base
Summary of Contents for Leggett & Platt Adjustable Base
- Page 1 Adjustable Base setup guide Foldable Base CUSTOMER SERVICE (800) 888-3078 toll free: 291-0081-B EDR15759 7/20 © 2020 Leggett & Platt, Inc. Adjustable Bed Group...
-
Page 2: Do Not Drop
DUE TO RISK OF INJURY, TWO ADULTS ARE REQUIRED TO HANDLE AND MOVE ADJUSTABLE BASE. STEP 1 WARNING Open the shipping carton. Carefully, lift adjustable base out of shipping carton and place on clean surface. PINCH POINT WARNING! KEEP HANDS AND FINGERS CLEAR WHEN STEP 2 UNFOLDING BASE. - Page 3 SETUP STEP 3 WARNING Remove and dispose of plastic spacers from base frame (FIGURE 2). CHILDREN / PET CHOKING HAZARD! REMOVE PLASTIC SPACERS FROM BASE FRAME. FIGURE 2 STEP 4 CAUTION Cut all orange zip-ties (FIGURE 3). Set mattress retainer (see FIGURE 3) aside. BE CAREFUL USING SHARP INSTRUMENTS.
- Page 4 SETUP STEP 5 Verify contents; inspect for damage. x6 - Legs (leg type x1 - Remote Control may vary) (Varies according to base type. Image may not match actual remote control.) x2 - Center Support Brackets x4 - 3-Inch Carriage Bolts and Nuts x1 - WRENCH x1 - Mattress...
- Page 5 SETUP STEP 6 A. Place a center support bracket over the mounting points on each side of base. B. Insert carriage bolts through the square holes in the center support bracket. Install nuts on carriage bolts (FIGURE 4). HAND TIGHTEN. C.
- Page 6 Extend power cord out head end of base. Remove protective covering from power cord plug. STEP 9 Rotate base over onto its legs. CAUTION WARNING HANDLE BASE BY FRAME ONLY. DO NOT DUE TO RISK OF INJURY, TWO ADULTS GRAB FABRIC. ARE REQUIRED TO HANDLE AND MOVE ADJUSTABLE BASE.
- Page 7 SETUP STEP 10 Install batteries in remote control, if applicable. REMOTE USER GUIDE Plug power cord into power outlet. Note: An electrical surge protection device is recommended (not included). Operate remote control to test base functions. See Remote Control User Guide for programming instructions (FIGURE 6).
-
Page 8: Usb Ports
SETUP STEP 12b (OPTIONAL) Insert the mattress retainer into the holes at the foot end of the base (FIGURE 8). FIGURE 8 STEP 13 Place mattress on base to complete assembly. USB PORTS Your base is equipped with USB ports on each side of the base (at the head end).
Need help?
Do you have a question about the Adjustable Base and is the answer not in the manual?
Questions and answers