Page 1
Owner’s Manual Model Nos. HT1224/FMB1224 Commercial Jump Starter/Chargers Made in U.S.A. WARNING WARNING - 12/24 VOLT MODELS READ ENTIRE MANUAL Never hook up a 12 Volt DC power source to a 24 Volt DC vehicle. This will CAREFULLY BEFORE grossly overcharge the 12 Volt power source and generate flammable OPERATING UNIT! gasses that may explode and cause property damage and/or bodily harm.
Page 2
Read these instructions completely before using the SOLAR Jump Starter/Charger and save them for future reference. Before using the SOLAR Jump Starter/Charger to jump start a car, truck, boat or to power any equipment, read these instructions and the instruction manual/safety information provided by the car, truck, boat or equipment manufacturer.
SAFETY INSTRUCTIONS 1. Use of an attachment not recommended or sold by manufacturer may result in a risk of fire, electric shock, or injury to persons. 2. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting unit. 3.
UNIT ASSEMBLY AND SETUP CHARGING INSTRUCTIONS Batteries have already been installed in units and are ready for immediate use. We recommend charging the unit upon receiving, so you will have maximum power for your jumping needs. Note: 12/24 Volt models will only charge when common connector with handle is plugged into the 12 Volt connector.
Page 5
OPERATING INSTRUCTIONS WARNING - 12/24 VOLT MODELS Never hook up a 12 Volt DC power source to a 24 Volt DC vehicle. This will grossly overcharge the 12 Volt power source and generate flammable gasses that may explode and cause property damage and/or bodily harm. JUMP STARTING For box units equipped with installed vehicle harness, leave vehicle running for best performance.
Page 6
4. A high quality battery emits fewer gases as it recharges. Using a high quality battery will extend charger and wiring life. Battery acid and petroleum resistant wiring is used in this unit. Battery fluid level must be checked every 30 to 45 days. BATTERY REPLACEMENT (HEAVY TRUCK HT1224) See Figure 1 REMOVING OLD BATTERIES 1.
Page 8
BATTERY REPLACEMENT (FIX MOUNT FMB1224) See Figure 2 REMOVING OLD BATTERIES: 1. Open box lid. 2. Disconnect cables and wiring from batteries. 3. Loosen hold-down by removing 1/4–20 bolt on end of box, by vehicle harness. This will allow hold-down to pivot up.
SOLAR Commercial Jump Starter/Charger is limited to the period of the express warranty set forth above. This warranty excludes and does not cover defects, malfunctions, or failures of your SOLAR Commercial...
Page 12
Owner’s Manual Model Nos. HT1224/FMB1224 Commercial Jump Starter/Chargers READ MANUAL CAREFULLY BEFORE OPERATING UNIT! WARNING: This product contains chemicals, including lead, known to the State of California to cause cancer, birth defects and other reproductive harm. Wash hands after handling.
WARRANTY AND TECHNICAL SUPPORT REGISTRATION Please complete the attached registration card to be eligible to receive FREE technical support, product updates and warranty service. TECHNICAL SUPPORT Technical support is available to registered users only. Call (800) 328-2921 Monday through Friday, 8:00 AM to 4:30 PM CST. THREE EASY WAYS TO REGISTER 1.
Page 14
NO POSTAGE NECESSARY IF MAILED IN THE UNITED STATES BUSINESS REPLY MAIL FIRST-CLASS MAIL PERMIT NO. 5445 SHAWNEE MISSION KS POSTAGE WILL BE PAID BY ADDRESSEE WARRANTY REGISTRATION CLORE AUTOMOTIVE 8735 ROSEHILL RD STE 220 LENEXA KS 66215-9901...
Need help?
Do you have a question about the HT1224 and is the answer not in the manual?
Questions and answers