Table of Contents
Advertisement
NOTE
NOTE
UNIVERGE WL Access Point (External-Antenna) Quick Installation Guide
•
Copy the MAC address(es) from the label(s) on the UNIVERGE WL AP
onto the corresponding location on the map. MAC addresses have the
format 000B85xxxxxx.
•
Attach the ceiling-mount clips to the bottom of the UNIVERGE WL AP
using the factory-supplied machine screws and washers.
•
Snap the ceiling-mount clips onto a hanging ceiling rail.
Figure -
Clipping the UNIVERGE WL AP and Ceiling-Mount Clips to a Hanging-
Ceiling Rail
•
Attach the cables to the sides of the UNIVERGE WL AP.
Make sure the cables are routed away from the UNIVERGE WL AP
antennas.
When the UNIVERGE WL AP is powered up and is associated with an
UNIVERGE WL Wireless Controller (Green/Power and Yellow/802.11b/g
and/or Yellow or Amber/802.11a LEDs lit), the UNIVERGE WL AP is
broadcasting its beacon signal(s). When this happens, complete the
installation as quickly as possible to remove yourself from within 8 inches
(20 cm) of the UNIVERGE WL AP to comply with FCC RF radiation
exposure guidelines.
You have installed the UNIVERGE WL AP. Repeat
UNIVERGE WL APs
for each UNIVERGE WL AP location, and then continue with
Step 5: Returning MAC
Information.
Step 4: Mounting the
1-17
Advertisement
Table of Contents
