Advertisement
Device Installation/ 设备安装
A. SD Card Installation/ 安装 SD 卡
Use the Phillips screwdriver to remove the camera bottom cover, and insert the SD card. You can refer to the SD
card icon on the maintenance window for the insertion direction. During SD card installation, you are advised to
turn the camera maintenance window downward and insert the SD card into the SD card slot from below to avoid
accidentally dropping the SD card into the camera.
使用十字螺丝刀将摄像机底盖卸下，插入 SD 卡，SD 卡插入方向参考维护窗上标识。安装 SD 卡时，建议将摄像机维护窗朝下，
避免不慎将 SD 卡掉入摄像机内部，造成设备故障。
CAUTION/ 注意
When the camera is not or cannot be connected to a video surveillance platform for a long time, you are advised to disable
video buffering to prolong the service life of the SD card.
Do not remove the protective film from the lens before the installation is complete.
若摄像机长时间无法接通平台或者不对接平台使用，建议手动关闭摄像机的平台离线缓存补录功能，以提高SD卡的使用寿命。
安装完成前切勿撕下镜头保护膜。
Install the pendant mount.
2
安装吊装支架。
B. Mounted Installation/ 室内吊装
Place the mount in the desired installation position. Use a marker to mark the screw locations. Use an 8 mm drill
1
bit to drill the holes to a depth of about 42 mm. Use a hammer to carefully drive the white plastic expansion
tubes into the holes.
将支架放置于安装位置 , 使用记号笔绘制螺钉安装位置，选择直径为 8mm 的钻头，钻取深约 42mm 的导孔。 使用羊角
锤将白色膨胀管打入钻好的孔内。
Remove the screws from the sunshield above the camera and fix the camera to the pendant mount.
3
拧下摄像机上方遮阳罩的螺钉，将摄像机固定在吊装支架上。
3
Advertisement
