Display & Error Codes - E-Wheels E2S V2 User Manual

3.2 Display & Error Codes
Display - power button
Long press the power button to turn the scooter on and off.
•
To turn on the lights the scooter must be turned on, and the power button must be short pressed once.
•
• To alternate between different modes, short press the power button twice (quickly).
Display Functions
Speed indication, power indication, error code indication, lights control, cruise control, gear level switch, and gear indicator.
Error codes: Check out our help center for guidance videos, tips and tricks. For questions regarding error codes, send your inquire to:
Norway: service@e-wheels.no
Europe: service@ewheels.se
Error codes are easily recognized as they show an "E-" followed by a number in the display. All error codes have different meanings and
are listed below:
4 - Short circuit - May occur from 1) short circuit. 2) loose cables. Open the standing bord and check all cables.
10 - Fault with the motherboard or bad connections - May occur from 1) bad connections. 2) defective cable between display and motherboard.
Trouble shooting: Look for bad connections or replace the motherboard.
11 - Incorrect connection (A) - Poor contact - May occur from 1) short circuit. 2) loose cables.
Check the yellow cable's connection between the motherboard and the motor.
12 - Incorrect connection (B) - Poor contact - Check the green cable's connection between the motherboard and the motor.
13 - Incorrect connection (C) - Poor contact - Check the blue cable's connection between the motherboard and the motor.
14 - Gas - Defective gas accelerator. May occur from 1) bad connection. 2) poor contact. Check connections.
If the problem persists, then the accelerator must be replaced.
15 - Brake handle - Make sure the brake handle is not stuck, and that the brake cable and the gas accelerator is intact.
If the problem persist, the brake handle must be replaced.
16 - Motor (A) - Fault with the motor sensor: yellow cable. Make sure this cable is not broken or damaged.
If the problem persists: replace the motor.
17 - Motor (C) - Fault with the motor sensor: blue cable. Make sure this cable is not broken or damaged.
If the problem persists: replace the motor.
18 - Motor (B) - Fault with the motor sensor: green cable. Make sure this cable is not broken or damaged.
If the problem persists: replace the motor.
28 - Motherboard (A) - One or several defective mosfets. Motherboard must be replaced.
29 - Motherboard (B) - One or several defective mosfets. Motherboard most likely needs to be replaced.
33 - Abnormally high temperature in battery - Turn off and let cool down. If the error code reoccurs, deliver the scooter for service.
50 - Battery over-voltage - Drive two minutes uphill/straight  regeneration/braking can then be used without errors.
53 - Battery over-voltage - Drive two minutes uphill/straight  regeneration/braking can then be used without errors.
54 - Motherboard (C) - One or several defective mosfets. Motherboard most likely needs to be replaced.
55 - Motherboard high temperature - Turn off and let cool down. If the error code reoccurs, deliver the scooter for service.
EN