6
REPAIR
6-1
Saw chain
6-1-1
Disassembling
[1]
[1]
[1]
6-1-2
Assembling
[2]
[3]
[1]
[3]
Fig. 2
[3]
[2]
[3]
Fig. 3
[1]
Fig. 4
[5]
[4]
[1]
1
Remove Batteries [1] (2 pcs).
2
Loosen Flange nut complete [2], then remove
Sprocket cover ass'y [3].
[2]
3
Lift up Saw chain section [1] and remove it.
Disassemble the machine after cleaning wood dust
etc. with a brush and an air duster.
Guide bar in all photos is not the actual one.
However, the removing/ assembling way is the
same.
1
Remove Guide bar case, then fit Saw chain [3] to
the grooves of Guide bar [1] and Sprocket 6 [2]
with care of the orientation in accordance with the
picture shown on Sprocket cover.
Pick up the top side of Guide bar [1] and swing the
rear side. Saw chain [3] can be fit into the groove of
Guide bar [1].
Adjust Drive gear [5] to put the hook of Tension
slide [4] into the lower hole of Guide bar [1].
5 / 32
Note
Tips