Advertisement
Quick Links
Advertisement
Related Manuals for zortrax DSS station
Summary of Contents for zortrax DSS station
- Page 1 Unpacking & First Use SOURCE: https://support.zortrax.com/dss-unpacking-first-use/...
- Page 2 Table Of Content In the Box Unpacking Setting up Operating...
- Page 3 In the Box The graphic shows the whole box content.
- Page 4 Unpacking Open the box and remove the cushioning. Use the handles to take the Zortrax DSS station out of the box. The handles are on both...
- Page 5 sides of the housing. Remove the security foil. The box also contains: rubber gloves, brush, drain pipe, quick start guide, rinsing basket.
- Page 6 Setting up Remove the top cover. Remove the rinsing basket.
- Page 7 Make sure that no foils or other elements are inside the device. Put the model in the rinsing basket.
- Page 8 Carefully place the basket inside the device. Fill up the device with warm water. Do not fill the device all the way to the top. Make sure that the water level is above the model.
- Page 9 Put the top cover back into place.
- Page 10 Operating Plug in the power cable and turn on the device. Press the POWER ON switch. Set the temperature and time with the buttons on the...
- Page 11 front. Recommended temperature settings for models printed with: – Z-PETG: between 40 and 50° C [104 and 122° F] – Z-PLA: max. 40° C [104° F] – Z-ULTRAT Plus: 50° C [122° F] – Z-SEMIFLEX: 50° C [122° F] Time settings should depend on the size and complexity of the model and the amount of support structures.
- Page 12 Remove the top cover. Be careful, the device contains hot water. Wear rubber gloves and safety goggles.
- Page 13 Remove the rinsing basket with the model. Rinse the model under running water and let it air dry. You can also use paper towels.
Need help?
Do you have a question about the DSS station and is the answer not in the manual?
Questions and answers