Description Of Numbered Items In The Diagram - Siemens ACC AP Technical Manual

5.2.1 Description of Numbered Items in the Diagram

A6V11367717
Item Description
Number
1 Power supply input – Vin, 12-24V DC
2 Power out with Vin voltage
(direct connection to Vin to allow daisy chaining of power to another devices)
3 Relay output 1. Potential free NC-COM-NO. Bistable function. Max 30V DC, 2A
4 Relay output 2. Potential free NC-COM-NO. Monostable function. Max 30V DC,
2A
5,6 General input 1 & 2 plus 3 & 4. Software defined.
For instance, closing contact or monitored input.
7,8 Open-collector output 1 & 2 plus 3 & 4. Software defined.
9 Wiegand Reader 1 and 2 bus connection plus power.
Max 700mA (Vin) or 200mA (12V) in total for both outputs.
10 Wiegand Reader 2
11 RS485 Communications Bus. See also 22.
Micro-SD card slot. Note that no card is supplied. Used for system restore /
12
update.
Battery socket. Type CR2032.
13
Note that the supplied battery should be mounted with the plus (+) downwards.
14 USB-A Full-speed –
15 USB-A Hi-speed –
16 Ethernet port RJ45 (Network)
17 Opening tamper switch. Protects for opening the lid.
18 USB-B connection to computer for setup.
19,20 Jumper – EOL Reader 1 & 2. End of line resistor for reader 1 & 2.
21,22 Jumpers – EOL communications 1 & 2. End of line resistor.
23 Jumper – Power reader 1 & 2. Voltage output for reader, Vin or 12V DC.
Default Vin
– .
Factory settings. Reset the unit to delivery status by pressing with a non-metal
24
stick for at least five seconds.
25 Removal tamper. Screw MUST be mounted to fulfill the tamper feature.
26 LED indicator.
Red: Controller is starting up
●
Orange: Application running
●
Green: Application running, connected with SiPass integrated
●
Off (Dark): Application not running. (This can occur during a Firmware
●
upgrade.)
ACC-AP Controller Diagram
future use
.
future use
.
Technical Specifications
Default
Default – ON
11 | 16
5
ON
– .
.