Page 2
The installation of this minipool is simple and immediate, however we advise you to read this manual carefully before installing it. The Treesse team is always available for any information or request for assistance that may be required during installation.
Unauthorised actions, tampering or Treesse invites you to protect the environ- modifications that do not follow the ment by disposing of the material in special information provided in this manual can cause separate collection bins.
Preliminary operations Shadow minipool PREPARATIONS AND CHOICE More information OF POSITION OUTDOOR INSTALLATION The pre-installation sheet supplied at the time of purchase provides all the information neces- Preparations: sary for a correct preparation of the installation To run the electric cables from the main electrical panel environments.
Transport and position Shadow minipool MOVING To move the minipool to the place of installation a suit- able lifting device (e.g., pallet jack) is required. As an alternative, provide for the availability of eight people. If the installation is indoor, before moving the minipool make sure that it can easily pass through the doors and hallways to reach the desired place of installation.
Transport and position Shadow minipool POSITIONING TEMPORARY POSITIONING The installation of the minipool should be done immediately upon receipt. In any case, once unpacked, if it is necessary to temporarily place it on a surface awaiting the installation, it will be necessary to place level concrete slabs having a minimum thickness of 5 cm under the entire bottom 80°C...
Installation Shadow minipool DESCRIPTION OF COMPONENTS 1 Control Panel 2 2-speed pump (water + recirculation) 3 Skimmer with paper filters 4 Skimmer cover panel 5 Electronic control unit 6 Heater (integrated with the control unit) 7 Chromotherapy control unit 8 Drain tap 9 Air regulators (under the pillow)
Installation Shadow minipool CONNECTIONS REQUIRED To be used, the minipool only requires OUTDOOR an electrical connection (power supply). INSTALLATION Room for the electrical Also prepare an electrical and plumbing connections connection to an exchanger (optional - if provided) - see following page.
Page 10
Installation Shadow minipool PREPARATION OF CONNECTION TO AN OPTIONAL EXTERNAL EXCHANGER (NOT SUPPLIED) Room for the electrical connections The Exchanger is the device with which domestic Inlet connection: water is heated 1 “1/4 female - socket (in this manual represented by a...
Page 11
Installation Shadow minipool PREPARATION OF CONNECTION TO AN “SPA PACK” EXTERNAL (OPTIONAL) Room for the electrical connections Inlet connection: 1 “1/4 female - socket Outlet connection: 1 “1/4 female - socket The circulator must be in- incoming stalled according to the cha-...
Installation Shadow minipool WATER SUPPLY More information WATER HARDNESS It is recommended to use ONLY tap water. If this Water hardness (TH) is determined by the total content is not possible refer to the "more information" of calcium and magnesium present in the water, coming section to the side.
Installation Shadow minipool CLEANING THE PAPER FILTER Cleaning/replacing the paper filter depends on how often the minipool is used. In general, rinse the cartridge every 2-3 weeks with clean water to remove hair and other foreign substances. Be careful to clean well between the folds of the filter.
ELECTRICAL CONNECTIONS The Treesse minipools are built in compliance with European laws (EN 60 335-2-60) and are tested during production to ensure the safety of the installer and user. The connection must be made by an experienced, qualified electrician.
Installation Shadow minipool SAFETY ZONE Local regulations prohibit any electrical installation (plug sockets, switches, lamps, etc.) in the area surround- ing the minipool for a distance of at least 60 cm and a height of 230 cm. TESTING AFTER INSTALLATION √...
First run Shadow minipool FILLING THE MINIPOOL Perform a preliminary cleaning of the minipool using a Manual filling with a garden hose bit of water and a mild detergent. Do not use cloths or cleaners that are abrasive, aggressive or that contain solvents because they could irreparably damage the surface of the minipool.
Shadow First run minipool Main page FIRST RUN After turning the power on at the main power panel, the top-side panel display will go through specific sequences. This sequence displays a variety of information regarding the configuration of the minipool. PRIMING MODE This procedure lasts 4-5 minutes, during which the PRIMING THE PUMP heating is deactivated to prevent any overheating in case of low or non-existent flow.
Shadow Alarms minipool If any alarms appear during initial startup, read the instructions provided in the following table. If the solution is not possible, immediately contact the Manufacturer to request technical support. In the meantime, do not try to repair or use the minipool but rather disconnect it from the electricity and water supplies.
Page 19
Shadow Alarms minipool MESSAGES CONNECTED DISPLAY SCREEN DESCRIPTION OF SIGNALS AND POSSIBLE SOLUTIONS TO WATER HEATING Problem description: There may be an insufficient water flow into the heater. Water heating is blocked for about a minute, until a new heating The water attempt is made.
Page 20
Shadow Alarms minipool SENSOR-RELATED DISPLAY SCREEN DESCRIPTION OF SIGNALS AND POSSIBLE SOLUTIONS MESSAGES Problem description: The sensors connected to the water temperature survey provide inaccurate indications (error margin of 2°C or 3°F). Temperature Solutions: If the problem persists, contact Technical Service.
Page 21
Alarms Shadow minipool SYSTEM DISPLAY SCREEN DESCRIPTION OF SIGNALS AND POSSIBLE SOLUTIONS MESSAGES Problem description: At power up, the system did not pass the checksum (system integrity check). This indicates a problem in the operating system. Memory fault - Solutions: Contact Technical Service.
Decorative panels Shadow minipool Equipment A - No. 2 panel per long side x 32 x 12 B - No. 2 panels per short side C - No. 8 4x15 Allen head screws D - No. 12 4x20 self-drilling screws (for fixing to tray) E - n.4 connection profile F - n.4 cover 4x15...
Under these conditions or when not used, advise the 80°C owner to use a fixed or mobile cover to protect the minipool (we recommend the optional Treesse covers). 176°F In addition to preserving the surfaces, the cover will keep the water hot and protected against falling leaves and other outdoor debris.
Page 27
Maximum care has been paid to guarantee the accuracy of this manual. The Manufacturer reserves the right to modify the equipment or the documentation at any time, without notice. Therefore there might be small differences between this manual and the product you have received: we apologise in advance for any inconvenience. The total or partial reproduction of this manual without the Manufacturer's consent is prohibited.
Page 28
www.gruppotreesse.it GRUPPO TRE S s.p.a. 01036 Nepi (VT) - Italy S.S. Cassia km. 36.400 Settevene industrial area tel. (+39) 0761 527242 fax (+39) 0761 527223 info@gruppotres.it...
Need help?
Do you have a question about the Shadow and is the answer not in the manual?
Questions and answers