Table of Contents
Advertisement
1
Wear full eye protection, non-slip
heavy-duty gloves, substantial
footwear, and long trousers at all times
while operating the product. Do not
operate the product when barefoot or
wearing open sandals.
3
1
Route the safety interlock cable through
the hole on the cable cover. Install the
cable cover until it clicks in place.
6
Connect the safety interlock system
cable to the seat cable.
2
Push the tabs on rear side of the cable cover, and remove the cover. Connect the
battery cables.
4
2
2
1
Remove the bolt and nut secured on the
seat mounting brackets.
7
Pull down the seat.
2
1
5
1
2
1
Install the seat, aligning the mounting
holes to the mounting bracket on the
mower. Secure the seat using the bolt
and nut on each side.
8
On the front side of the mower, install
the upper steering shaft over the lower
shaft. Secure the shaft with a bolt and
nut.
3
1
3
2
2
3
1
2
3
13
Getting Started
3
6
9
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the RM300E and is the answer not in the manual?
Questions and answers
mower cutting disengages after starting
The cutting on the Ryobi RM300E mower disengages after starting for the following possible reasons:
1. Operator is not fully seated: Fully sit down on the seat to ensure the safety interlock system is engaged.
2. Blade engage knob is down: Pull up the blade engage knob to activate the blades.
3. Battery charge is low: Charge the battery to ensure sufficient power.
4. Debris build-up under the mower deck: Clean the underside of the mower deck to prevent interference.
5. Side discharge interlock switch is not pressed fully: Ensure the side discharge chute is fully pressed down to engage the interlock switch.
This answer is automatically generated
installed new batteries turned key on charging indicates two red bars mower will not move
If the Ryobi RM300E mower has two red bars on the charger after installing new batteries and won't move, the battery charge may be too low. The manual states that when the battery charge indicator is in the red zone, the blades will shut off, and the mower may become stranded. The solution is to turn the key switch to the off position and push the mower back to the charging location. Ensure the batteries are properly connected and fully charged before use.
This answer is automatically generated
My 3 year old RM300E is not charging, green light flashing on mover. no green light on charger when plug into the mover, batteries are new.
The Ryobi RM300E is not charging because the battery pack may be defective. A flashing green light on the mower and no green light on the charger indicates a charging issue. Try resetting the charger or reinserting the battery. If the issue repeats, test with a different battery. If the other battery charges normally, the original battery is likely defective and should be disposed of properly.
This answer is automatically generated
@Mr. Anderson how do I reset the charger?
charger use to get warm to the touch, but not now, how long do chargers usual last ?
where do I get a replacement charger for my Ryobi RM300E riding lawn mower?
You should use the OP48RM or SC-48 charger for the Ryobi RM300E riding lawn mower.
This answer is automatically generated