Canon VB-C500D Start Manual page 54

Step 3 Perform Initial Setting of the Camera
Note
To set the IP address from the DHCP server, set an address from VB Initial Setting Tool to
enable communication with the setup PC and change the setting of [IP Address Setting]
under [Network] ("LAN" in Operation Guide) on the Setting page to [Auto (DHCP)].
The camera will stop issuing IP address assignment requests in 20 minutes after its power
is turned on, upon which detection by VB Initial Setting Tool will be disabled. In this case,
turn on the camera again.
To restore the factory settings, see "Restore Settings" in Operation Guide.
2-12
This completes the initial setting.