Load Work File - Charmhigh CHM-T36VA Operating Manual

and clicking calibrate to verify the component is now centered;
(4) Save: Saves the set offsets for the PCB calibration;
Figure
10.17. Window for calibrating PCB points.

10.2. Load Work File

The load work window is used to run the machine and monitor its progress.
(1) Current step: Showing current component step and total number, click to set the
component step which will mount next;
(2) PCB ID: For batch mode, show current PCB ID number and total. Click to set
current PCB number, which will mount next;
(3) Place count.: Show total count of placed components;
(4) PCB count: For batch mode, show total count of PCB boards;
(5) Average speed: Show average mounting speed, in chips per hour;
(6) Elapsed time.: Run time;
(7) Adjust Tray Start: When feeders are defined in the IC tray, this button appears.
Click to set the start IC number;
(8) Up camera (bottom left): Click to watch image of up camera;
(9) Down Light (2
(10) PCB calibrate (3
(11) Vacuum checks (4
(12) Head to Home (5
nd
left): Click to toggle light on and off;
rd
left): Click to calibrate the PCB position;
th
left): Click to toggle on and off the vacuum checks;
th
left): Click to send head to home position, at back-right;
23