Sealey VS913 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Hot surfaces
Refer
to
instructions
1. SAFETY
WARNING! Ensure that Health & Safety, local authority and general workshop practice regulations are adhered to when using this
‰
equipment.
Familiarise yourself with the applications, limitations, and potential hazards of the Thermal Camera.
9
Keep the Thermal Camera clean and in good condition.
9
Protect the Thermal Camera from the following:
9
- Thermal shock caused by large and/or rapid ambient temperature change.
- High temperatures.
DO NOT get the Thermal Camera wet or use in damp or wet locations or areas where there is condensation.
8
DO NOT use the Thermal Camera for any purpose other than that for which it is designed.
8
DO NOT allow untrained persons (particularly children) to operate the Thermal Camera.
8
DO NOT operate the Thermal Camera when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
WARNING! The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions and
8
situations that may occur. It must be understood that common sense and caution are factors which cannot be built into this
product, but must be applied by the operator.
2. INTRODUCTION
Thermal imaging camera for the detection of high and low temperature. Heat-mapped colour palettes and temperature reading.
Includes on-screen cursor to accurately locate minimum/maximum temperature variation. Suitable for many industries including
automotive, building and electrical.
3. SPECIFICATION
Model no.: .................................................................. VS913
Colour Palette ...................................................................... 3
Emissivity .............................................................. On Screen
Field of Vision .......................................................... 33
Image Mix (Camera to Thermal) ............................... Thermal
Memory Capacity ................................4Mb SD Memory Card
Power Source .................................... 4 x AAA (Not Included)
Resolution ........................................................ 32 x 32 pixels
Screen Size ....................................... 1.8" 128 x 160mm TFT
Temperature Range .................................... -20
4. OPERATION
4.1. BATTERY INSTALLATION
4.1.1. Use a small cross-head screwdriver to remove the battery cover (fig.1).
4.1.2. Fit 4 AAA batteries (not supplied) and replace cover (DO NOT over tighten).
4.1.3. Press and hold the On/Off button (fig.1) for 2-3 seconds until the start screen appears.
4.2. HOME SCREEN DISPLAY (fig.2)
4.2.1. Press the "OK" button (fig.3.6) to display the settings menu. Using the Ʌ or V buttons (fig.3.8)
highlight the field you wish to set/adjust and press "OK".
4.2.2. Once you have the selected the options to suit your usage, use the return button (fig.3.7) to
start using the unit. Options are:
SD Card: View images taken or format SD card
Colour: Three variations to choose from.
Emissivity: Five settings (.95, .90, .80, .60, .30) See chart (fig.4) overleaf.
Temperature units: Celsius or Fahrenheit.
Date/Time: 12 or 24 hour clock.
Auto Off: Off, 1, 2, 5, and 10 minute settings.
© Jack Sealey Limited
THERMAL IMAGING CAMERA
VS913
MODEL NO:
I
x 33
o o
C to +650 C
o o
Original Language Version
fig.1
fig.2
VS913 Issue 1 09/04/20