Table of Contents
Advertisement
Safety Check after Servicing
Examine the area surrounding the repaired location for damage or deterioration. Observe that screws, parts and
wires have been returned to original positions. Afterwards, perform the following tests and confirm the specified
values in order to verify compliance with safety standards.
1. Clearance Distance
When replacing primary circuit components, confirm
specified clearance distance (d) and (d') between
soldered terminals, and between terminals and
surrounding metallic parts. (See Fig. 1)
Table 1: Ratings for selected area
AC Line Voltage
Region
U.S.A. or
110 to 130 V
Canada
Note: This table is unofficial and for reference only. Be
sure to confirm the precise values.
2. Leakage Current Test
Confirm the specified (or lower) leakage current
between B (earth ground, power cord plug prongs) and
externally exposed accessible parts (RF terminals,
antenna terminals, video and audio input and output
terminals, microphone jacks, earphone jacks, etc.).
Measuring Method: (Power ON)
Insert load Z between B (earth ground, power cord plug
prongs) and exposed accessible parts. Use an AC
voltmeter to measure across both terminals of load Z.
See Fig. 2 and following table.
Table 2: Leakage current ratings for selected areas
AC Line Voltage
Region
U.S.A. or
110 to 130 V
Canada
Note: This table is unofficial and for reference only. Be sure to confirm the precise values.
All manuals and user guides at all-guides.com
Clearance
Distance (d), (d')
≥ 3.2 mm
(0.126 inches)
Load Z
0.15 µF CAP. & 1.5 kΩ
RES. Connected in parallel
1-2-4
Chassis or Secondary Conductor
Primary Circuit
d'
d
Exposed Accessible Part
Z
AC Voltmeter
(High Impedance)
Earth Ground
B
Power Cord Plug Prongs
Leakage Current (i)
Earth Ground (B) to:
Exposed accessible
i ≤ 0.5 mA rms
Fig. 1
Fig. 2
parts
T2221_ISP
Advertisement
Table of Contents
