Hitachi 61HDX98B Manual page 63

DP-8 5 C H A S SIS CENTERING M A G N E T v s . B E A M F O R M M A G N E T
N O T E :
The Centering Magnet and Beam Form and Beam Alignment magnets are shown on the
right to avoid confusion when adjusting.
Figure 1 shows the Centering magnet. This magnet is normally made of metal and is
located up against the back side of the yoke assembly.
(Not down on the neck of the CRT)
Figure 2 shows the Beam Form and Alignment magnet. This magnet is normally made of
plastic and is located close to the CRT PWB on the neck of the CRT.
Figure 2
CENTERING MAGNET
Figure 1
BEAM FORM & ALIGNMENT MAGNET
ADJUSTMENT
TABS
PICTURE TUBE SIDE
4-POLE BEAM SHAPE
CORRECTION MAGNET
ZERO FIELD SPACER
(NO ADJUSTMENT)
2-POLE BEAM
ALIGNMENT MAGNET
P A G E 0 8 - 13