Sealey SSC900 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear protective
instructions gloves
1. SAFETY
Keep crane, lifting slings, support and beams in good working order and condition. Follow the inspection requirements as described
9
in Section 6, Maintenance. Take immediate action to repair or replace damaged parts by contacting your supplier.
Ensure that all accessory lifting devices are suitable. If crane is damaged, remove from service immediately.
9
Ensure that the crane is securely fixed to the surface or vehicle on which it is to be mounted.
9
Keep children and unauthorised persons away from the working area.
9
Keep working area clean and tidy, free from unrelated materials and ensure that there is adequate lighting.
9
Ensure that load does not exceed the maximum lifting capacity of the crane. Overloading the crane is dangerous. Where
9
appropriate, use only the lifting points recommended by the manufacturer of the item to be lifted, e.g. vehicle engine.
Before lifting the load ensure that the crane boom is in the lowest practical position, that there are no obstacles which may snag the
9
load whilst it is being lifted and that the area above the boom is clear.
To avoid injury, be fully aware of your own and other persons locations in relation to the lifting, and lowering, of the load.
9
Keep a sound footing and balance, and ensure the floor is not slippery, and wear non-slip footwear.
9
Ensure boom extension locking pin and 'R' pin are in position before lifting.
9
Ensure the centre of gravity always remains inside the crane base.
9
DO NOT harness the load at an angle or use any attachments not verified as fit for purpose.
8
DO NOT allow the load to swing during lifting.
8
DO NOT allow the load to drop suddenly. Lower load with care, ensuring that you are fully aware of the condition of the surface onto
8
which the load is to be placed.
DO NOT load crane beyond its rated capacity for each specified boom extension position as indicated in Section 3. The capacity of
8
the crane reduces as the boom is extended.
DO NOT position any part of your body beneath the load.
8
DO NOT attempt to adjust the safety valve, which has been set and sealed by the
8
manufacturer.
DO NOT use this crane to perform a task for which it is not designed.
8
DO NOT use whilst under the influence of drugs, alcohol or intoxicating
8
medication.
DO NOT climb on the crane.
8
When not in use store in a safe, childproof area.
9
WARNING! Failure to heed safety and warning instructions may result in damage
‰
and/or personal injury and will invalidate the warranty.
2. INTRODUCTION
Unique 360° locking swivel base for easy rotation. Mounts easily onto any strong and stable
surface including loading bays, 4x4s, flatbed trucks and trailers. Heavy-duty chain and hook
with safety clip. Dead man's control release valve allows fine adjustment for safe, controlled
lowering of load. Available in two capacities.
2.1. IDENTIFICATION :
Supplier: Sealey Power Products,
Kempson Way,
Suffolk Business Park,
Bury St Edmunds,
Suffolk,
IP32 7AR.
Model No: SSC900
© Jack Sealey Limited
900KG STATIC MOUNTED CRANE
MODEL NO:
Wear safety
footwear
Original Language Version
SSC900
SSC900 Issue 3 (HF) 22/04/2021