Attaching And Removing Attachments - Volvo L20B Owner's Manual

Travel
50

Attaching and removing attachments

C
B
Attaching and removing
attachments
Installation and removal of quick change
1
working attachments without additional
hydraulics
2
Install the working attachment (e.g. bucket, load-
ing fork etc.).
– Drive the loader forward up to the working attachment.
– Turn the cock valve on the attachment carrier to position (A).
– Shift lever (1) to "Lifting", until the centring pins (C) of the
M200054A
– Actuate lever (2) "Tipping back", until the working attachment
– Shift lever (2) backwards until the locking pins (D) protrude from
– Shift lever (2) to middle position (neutral).
– Shut the engine down.
– Turn the cock valve on the attachment carrier to position (B).
A Cock valve in position "Open"
B Cock valve in position "Closed"
C Locating pin
M300051A
D Locking pin
C
A
Check whether the working attachment is properly locked
and secured by actuating lever (1) from "Tipping back" fully
to "Tipping".
D
M300049A
SW-carrier (see illustration) have picked up the working
attachment.
lifts off the ground.
the receiving bores of the working attachment for approx.
10 mm.
ATTENTION!