Tray Panel - Mitsubishi Electric DD-8020 Service Manual

<Mounting >
1. The spring for tray side pressure is inserted into the
portion "A". (Refer to Fig. 2-1-2.)
2. By referring to Fig. 2-1-3, insert the spring normally
and mount the clamper stay.
This part should be touch
to the left side of the tray.
OK
Mechanism
chassis assembly
Press down by finger
unitil fix the clamper assembly
OK
No floating
Fig. 2-1-3
NG
NG
Tray
Spring
NG
Floating NG

1-1-3. Tray Panel

<Tray Ejection>
1. Slide the slider (2) of the mechanism chassis assembly
(1) with a screwdriver, etc. in the arrow direction, so
that the tray (3) is ejected.
Note:
• Take care not to damage the pickup and other parts.
Screw
driver
Mechanism
chassis assembly (1)
<Tray Panel Removal>
1. Eject the tray (3).
2. Twist the tray panel (4) a little in the arrow A direction
with the tray (3) hold by hand to release two claws and
lift up the tray panel (4) in the arrow B direction, then
the tray panel (4) is removed.
(Refer to Fig. 2-1-5.)
3. When mounting the tray panel (4), insert the tray panel
(4) along the grooves of the both sides of the tray (3)
until clicking.
2-2
Slider (2)
Tray (3)
Front panel
Fig. 2-1-4