Sharp WH-A55 Service Manual page 14

Note : For disassembly
Cut off the lead wire from PCB control ass'y.
1. Remove the body in accordance with "REMOVE OF BODY".
2. Remove split pin holding the breaker angle support to the breaker.
3. Remove 2 screws holding 2 breaker lead wires to the breaker.
4. Remove 2 screws holding the breaker to the back cover.
5. Now the breaker is free.
Breaker angle support
Breaker
Breaker lead wire
White lead wire
Orange lead wire
Orange lead wire
REMOVE OF BREAKER
Blue lead wire
Fig. 28
Fig. 29
14
Volume SW.
Split pin
Screw
Back cover