Porsche Cayenne 2020 Owner's Manual page 282

Transmission
e Slowly remove your foot from the accelerator
A
pedal.
B
The system evaluates the driving data and auto-
C
matically initiates coasting mode in appropriate
driving situations.
D
Initiating coasting mode manually
E
b b Cayenne, Cayenne Coupé, Cayenne S,
F Cayenne S Coupé, Cayenne GTS,
Cayenne GTS Coupé, Cayenne Turbo,
G
Cayenne Turbo Coupé
b b NORMAL driving mode selected.
H
b b Operating mode D selected.
I
b b Porsche Stability Management (PSM) active.
b b Cruise control mode not active.
J
b b Adaptive Cruise Control (ACC) not active.
K
b b Porsche InnoDrive (PID) not active.
L b b No major inclines or slopes.
b b Auto Start Stop function switched on (only Cay-
M
enne, Cayenne Coupé, Cayenne S,
N
Cayenne S Coupé, Cayenne Turbo,
Cayenne Turbo Coupé).
O
1. Remove your foot from the accelerator pedal
P
completely.
Q 2. Use the gearshift paddle or the selector lever to
manually shift up beyond the highest possible
R
gear.
Coasting mode is initiated.
S
Exiting coasting mode
T
e Press the accelerator pedal.
U
– or –
e Shift gear using the shift paddle or selector lever.
V
The engine is engaged again and coasting mode
W
is exited.
X
Driving off with Performance Start
Y
The Performance Start function achieves maximum
Z
acceleration from a standing start.
280
Loss of control over the
WARNING
vehicle or endangering
other road users
In some situations (poor road conditions, driver in-
attention, etc.) control over the vehicle may be lost
or other road users may be endangered as a result.
e Only use Performance Start on public roads if the
road and traffic conditions permit.
e Do not endanger other road users when using
Performance Start.
Information
Stresses on components increase significantly when
driving off at maximum acceleration compared to
normal driving off.
b b Engine is at operating temperature.
b b SPORT PLUS mode activated.
1. Press the brake firmly with your left foot.
2. Quickly depress the accelerator pedal fully and
hold it down.
The engine speed levels off automatically. A
message appears on the instrument cluster indi-
cating that the Performance Start function is
active.
3. Release the brake within a few seconds.
Driving off with e-Launch
b b E-Hybrid vehicles
The e-Launch function is used to achieve maximum,
purely electric acceleration from a standstill.
b b The high-voltage battery should be as fully
charged as possible.
1. Activate E-POWER mode.
2. Press the brake with your left foot.
3. Press the accelerator pedal until a message re-
garding an active e-Launch function appears in
the instrument cluster and stop at that point.
4. Release the brake within a few seconds.
Information
In the E-POWER driving program, the accelerator
pedal has a hybrid-specific end point. When this end
point is exceeded, the combustion engine is started.