Table of Contents
Advertisement
3
Connect the monitor cord to the jack of camera
mounting shoe G.
Then, fasten the latches securely, and attach the grip.
For details, see below.
For DCR-HC90/HC90E/HC43/HC43E/HC42/HC42E/HC40/HC40E/HC39E/
HC33/HC33E/HC32/HC32E/HC30/HC30E/HC22E/HC21/HC21E/HC20/HC20E/
HC19E/HC18E/HC17E/HC16E/DVD803/DVD803E/DVD703/DVD703E/
DVD653/DVD653E/DVD602/DVD602E/DVD403/DVD403E/DVD203/
DVD203E/DVD202E/DVD103/DVD103E/DVD92/DVD92E/PC109/PC109E/
PC108/PC108E/PC107/PC107E/PC106E
4
Attach the front shell to the rear shell. Hold
both shells firmly and fasten the 3 latches
securely.
Take care not to pinch the remote, microphone,
and monitor cords. If this happens water may
leak in.
For details on handling the O-ring, see page 22.
5
Attach the grip.
Fasten the screw tightly.
Now you have finished the preparations.
Be sure to check that the equipment operates correctly and that there is no water leakage
before you dive (see page 14).
The cords are placed in the plug
holders of the marine pack at the
factory. Pull the plugs out of the
holders when in use.
Take care not to pinch the cords.
GB
13
-GB
Advertisement
Table of Contents
