Operation - MULTIQUIP WHITEMAN PRX Operation Manual

The following section is intended to assist the user with the
operation of the PRX ride-on power float. It is extremely
important to read this section carefully before attempting
to use the float in the field. DO NOT operate the float until
this section is thoroughly understood.
CAUTION
ALWAYS wear approved eye and
hearing protection while operating the
float.
WARNING
NEVER operate the float in a confined
area or enclosed area structure that does
not provide an ample, free flow of air.
NOTICE
This power float is equipped with a safety seat switch.
The rotors will not turn unless an operator is sitting in
the seat or the drive bypass function is enabled.
STARTING THE ENGINE
1. While standing in front of the float, grasp one of the
grab bars and place a foot on one of the steps. Lift
yourself onto the float platform and sit down in the
operator's seat.
NOTICE
DO NOT grab the steering control joysticks to lift
yourself onto the float. Damage to the joysticks may
result. ALWAYS use the grab bars to lift yourself onto
the float.
2. Insert the ignition key into the ignition switch
(Figure 35).
KEY
Figure 35. Ignition Key Switch
PAGE 36 — PRX RIDE-ON POWER FLOAT • OPERATION MANUAL — REV. #1 (01/05/21)
OFF
ON
START
3. Turn the ignition key clockwise to the ON position
(Figure 35). The digital display will turn on and the
main screen (Figure 36) will appear on the display.
Figure 36. Digital Display (Main Screen)
4. Select GAS or LPG fuel mode. Press the fuel selector
button (Figure 37) to toggle between gasoline and LPG
fuel systems. The selected fuel system is shown on the
digital display. The fuel selector button will illuminate
when LPG is selected.
FUEL SELECTOR
BUTTON
Figure 37. Fuel Selector Button
NOTICE
Fuel modes can be switched while the float is running.
The engine does not need to be stopped when
changing fuel modes.

OPERATION