D-Link R15 Technical Support Setup Procedure

Technical Support Setup Procedure

How to restore the R15 router to Factory Defaults?

Step 1:

Connect your device to the Wi-Fi of the R15 router.

Step 2:

Open a browser and type http://R15-XXXX.local./ or http://192.168.0.1 then press Enter

*XXXX Last 4 digit of the router's mac address

Step 3:

Enter your administrator password.

If you have not changed the default password, check on the configuration card. Click Login.

Table of Contents

Do you have a question about the R15 and is the answer not in the manual?

Page 1 Step 1: Connect your device to the Wi-Fi of the R15 router. Step 2: Open a browser and type http://R15-XXXX.local./ or http://192.168.0.1 then press Enter *XXXX Last 4 digit of the router’s mac address Step 3: Enter your administrator password.
Page 2 Technical Support Setup Procedure Step 3: Go to Management > System Admin > System i. Put your desired admin password in the Password box ii. Click Restore Button iii. Click OK iv. Wait for the countdown v. Restore to factory default successful Please note that restoring the settings to the factory defaults will erase all settings, including any rules you have created...
Page 3 Technical Support Setup Procedure Reset Pin hole 1. Keep the router powered on 2. Insert a paperclip in the hole 3. Wait for the power LED turns orange (all other LEDs should be off) 4. Release to reset the router to default settings. Please note that restoring the settings to the factory defaults will erase all settings, including any rules you have created --End--...