Table of Contents
Advertisement
21. Check that each connectors are connected securely.
22. Set around each cables as shown in below figure.
HDVD cable
USB cable
HDVD cable
AC wire clip
23. Install the card stopper.
24. Install the PCI duct.
25. Install and fix the AV I/O block to the unit.
n
When installing, be careful not to catch the each
cables.
DMW-S01NL/S02NL/ST001
1-10-2. Setup after installing
1. Clear the hardware configuration information.
(Refer to Sec. 5-1-4. 2. Advanced)
AUD cable
1 Turn on the power of the unit.
2 When the "SONY" logo appears on the screen,
3 Wait until BIOS setting screen is displayed.
4 Select the "Advanced" menu using arrow key
5 Select "Advanced" at most top item from the
6 Select "Reset Configuration Data" at second top
Cable clamp
7 As default setting is "No", so press the <Enter>
8 After setting, select "Save & Exit" (<F10>), press
2. Install the application and driver.
3. Perform the operating confirmation using self diagnos-
tics functions of the IF02 Assy (DMW-IF02) utility.
(Refer to Sec. 5-7-4)
4. Connect the Fibre channel storage unit DMW-ST001
to the unit, perform the disk reconfiguration.
(Refer to Sec. 5-6-5)
n
When reconfiguring, all created data file has been cleared
on the DMW-S01NL.
1-10. Installation of DMW-IF02
press the <F2> key.
<→>.
"Advanced" menu, press the <Enter> key.
item from the "Advanced" menu, press the
<Enter> key.
key to set "Yes".
the <Enter> key.
1-51
Advertisement
Table of Contents
