Advertisement
2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Description
Torx screwdriver
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
3.1.1
Mechanism disassembly: remove the front panel (clip fit – two clips top, two bottom), and remove the lid and the
base. You will need to cut the 4 x tamper-proof tapes, top and bottom to clip off the lid and the base.
3.1.2
Remove the main PCA. Disconnect all FFC / FPC connectors and 1 x cable connector The main PCA is > 10
square cm's. See image 1. When the PCA is removed, remove the PCA shield - located underneath the main PCA
and secured by 2 x T-10 screws – see image 1.
3.1.3
Remove the CMWP PCA. Slide the cartridge assembly 2 cm back into the mechanism. Remove 5 x T-5 screws
securing the PCA and remove from the mechanism. PCA is > 10 square cm's – see image 2.
3.1.4
Remove the 2 x reel motor PCAs. Remove the tape reel. 3 x T-10 screws and cut the tape. Once removed,
remove 3 x T-8 screws securing the front reel motor PCA and 3 x T-8 screws securing the rear reel motor PCA.
Both reel motor PCAs are > 10 square cm's. See image 3.
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below to identify the items
contained in the product that require selective treatment (with descriptions and arrows identifying locations).
1) Main PCA.
T-10
Above: PCA shield
2) CMWP PCA.
5 x T-5 screws
EL-MF877-00
Template Revision A
T-10
PCA > 10 square cm's
CMWP PCA > 10 square cm
Tool Size (if
applicable)
T5, T8 & T10
Page 2
Advertisement
