Page 2
The monitor measures these contractions and converts the on the upper arm. This blood pressure monitor (HL858A2-LT) detects the appearance information to a digital value. This is the result displayed on the monitor screen. Once the of irregular heartbeats during measurement;...
• Rest at least 5 - 10 minutes before taking a measurement. • Consider the electromagnetic compatibility of the device (ex. power disturbance, radio • To allow your blood vessels to return to the condition prior to taking the frequency interference etc.) Please use it indoor only. measurement, please wait at least 3 - 5 minutes in between measurements.
SYMBOL DEFINITIONS SYMBOLS DEFINITIONS This symbol appears when the battery power is excessively low or the polarity reverses. Battery We suggest you replace all batteries with new ones, and make sure the +/- Symbol polarities are properly positioned. Pulse Symbol Once pulse is detected, the symbol flashes with each pulse beat.
Page 5
SETTING THE DATE & TIME POWER SUPPLY OPTIONS 1. Press START / STOP to turn on the monitor. The device will enter This monitor is designed for operation with batteries or an AC / DC adapter. Use only a STANDBY MODE. compatible AC / DC adapter with required voltage and current as indicated in this manual.
Position the artery mark over the main artery (on the inside of your • If the cuff inflates without stopping, unwrap the cuff immediately. arm). • Do not press the START / STOP button if the cuff is not wrapped around your upper arm. Tip: To locate the main (brachial) artery, press 2 fingers •...
RECALLING DATA LIMITED WARRANTY 1. Press + button to select User 1 or 2. This product has a limited warranty of 3 year(s) on the blood pressure monitor, 2 year warranty 2. Press M button to enter Memory Mode. on the cuff and accessories (except batteries) from the original date of purchase against •...
Otherwise, degradation any interference received, including interference that may cause undesired operation. of the performance of this equipment could result. HL858A2-LT ESSENTIAL PERFORMANCE PER IEC 80601-2-30 ADDITIONAL Waste of electrical and electronic Discard the used product to the recycling collection point equipment (WEEE) according to local regulations.
Page 9
APPENDIX APPENDIX Guidance and manufacturer’s declaration – electromagnetic emissions Guidance and manufacturer’s declaration – electromagnetic immunity The device is intended for use in the electromagnetic environments listed below, and should only be The device is intended for use in the electromagnetic environments listed below, and should only be used in such environments: used in such environments: Emission test...
Page 10
Guidance and manufacturer’s declaration – electromagnetic immunity Test specications for enclosure port immunity to RF wireless communications equipment. The device is intended for use in the electromagnetic environments listed below, and should only be Test frequency (MHz) Modulation IMMUNITY TEST LEVEL (V/m) used in such environments: Immunity IEC 60601 test...
Need help?
Do you have a question about the HL858A2-LT and is the answer not in the manual?
Questions and answers