Table of Contents
Advertisement
Important safety information
This unit has been produced according to all current safety regulations. The following safety tips should
safeguard users against careless use and the dangers connected with such use.
•
Although this appliance has been carefully manufactured and rigorously checked prior to leaving the
factory, as with all electrical appliances it is possible for problems to develop. If you notice smoke, an
excessive build-up of heat or any other unexpected phenomena, you should disconnect the plug from the
mains power socket immediately.
•
Ensure that the unit is sufficiently ventilated! Never place next to or underneath curtains!
•
This set should be only be connected to an AC 220~240V / 50Hz mains power supply - do not attempt to
connect it to any other type of supply.
•
The apparatus must be connected to a main socket outlet with a protective earthing connection.
•
The socket-outlet must be installed near the equipment and easily accessible.
•
Any repairs must be carried out by qualified service personnel only.
•
Do not open this unit. A non-expert attempting to repair the unit could be dangerous and potentially cause
a fire hazard.
•
Keep away from rodents. Rodents (and also cockatiels) enjoy biting into electric flexes.
•
The animal can cause a short cut (fire hazard!) and receive a fatal electric shock.
•
Always hold plug when pulling out plug from power mains supply system. Do not pull on flex. The flex can
become overloaded and cause a short cut.
•
Never wet clean. Only use a damp cloth, the same as when cleaning furniture.
•
Set up unit so that no one is able to trip over the flex.
•
Only use the unit on a stable, shock-free base in order to avoid any danger from falling.
•
Take note that toddlers can pull the unit down from the table or cupboard by means of its flex. Children
can hurt themselves when doing this.
•
Do not use the unit near heat sources. The casing and flex could be damaged by the impact of heat.
•
The screen is made of glass and can break if damage is done to it. Be careful when collecting sharp-
edged glass splitters.
•
You could be hurt or the unit could be damaged.
•
If the unit is mounted on the wall, contact the shop where you purchased the unit for advice, and leave the
installation work to experts. Incomplete installation work can cause you injuries.
•
When installing the set on a wall, allow at least 10 cm clearance between the rear of the set and the wall.
Clearance of less than 10 cm will obstruct the vents and cause the interior of the set to overheat, resulting
in faults or damage to the set.
•
Taking fall-prevention measures
- If these measures are not taken, the unit can fall and you could be injured.
- Contact the shop where you purchased the unit to obtain full details of the measures.
•
When a TV stand is used,
- Ensure the unit is fully on the stand and placed in the centre.
- Do not leave the stand doors open.
- You could be hurt as a result of the unit falling or breaking, or your fingers being caught or jammed. Take
extra precautions if you have children.
•
Avoid placing the unit on any surfaces that may be subject to vibrations or shocks.
•
To protect the unit during a thunder storm unplug the AC power cord and disconnect the aerial. Caution:
Do not touch the aerial connector.
•
When you leave your home for a long period of time, unplug the AC power cord for safety reasons.
•
The unit becomes warm when in operation. Do not place any covers or blankets on the unit in order to
prevent overheating. The ventilation holes are not to be blocked. Do not set up near radiators. Do not
place in direct sunshine. When placing on a shelf leave 10 cm free space around the whole unit.
•
Make some space around TV (Correct shelf assembly).
•
The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such
as vases, shall be placed on the apparatus.
Liquids spilled into the unit can cause serious damage. Switch the set OFF and disconnect the mains
power supply, then consult a qualified service person before attempting to use the unit again.
•
Moisture condensation occurs, for example, when you pour a cold drink into a glass on a warm day. Drops
of water form on the outside of the glass. In the same way, moisture may condense on the optical pick-up
lens inside this unit, one of the most crucial internal parts of the unit.
•
Moisture condensation occurs during the following cases.
- When you bring the unit directly from a cold place to a warm place.
- When you use the unit in a room where you just turned on the heater, or a place where the cold wind
from the air conditioner directly hits the unit.
- In summer, when you use the unit in a hot and humid place just after you move the unit from an air
conditioned room.
- When you use the unit in a humid place.
•
Do not use the unit when moisture condensation may occur.
•
If you use the unit in such a situation, it may damage discs and internal parts. Remove the disc, connect
the mains lead of the unit to the mains power outlet, turn on the unit, and leave it for two or three hours.
4
After two or three hours, the unit will have warmed up and evaporated any moisture. Keep the unit
connected to the mains power outlet and moisture condensation will seldom occur.
51K0201A_ENG.indd 4
Location of controls
4
5
Disc slot
6
7
8
9
10
Adjusting the angle of the base
You can adjust the angle of the TV-screen
for 3° forward or for 10° backward from
vertical angle.
Hold the base of the TV while adjusting
the angle.
Description of Indicators and Controls
1. Remote sensor
2.
(Power) indicator: The LED indicator lights up red in standby mode, and green in the power ON
mode.
3. Loudspeakers
4.
(EJECT): Eject a disc.
5.
(Volume) +/– buttons / In Menu: Setting.
6.
(Channel)
/PLAY (
) button: Press
memory. DVD mode : Playback. In Menu: Setting. In Standby: Turning on the unit.
7.
(Channel)
/STOP ( ) button: Press
memory. DVD mode : Stop. In Menu: Setting. In Standby: Turning on the unit.
8. MENU button: To display the menu screen.
9.
(INPUT SELECT) button: Select input mode for TV/AV1/AV2/COMPONENT/HDMI/PC/DVD. In
Menu : Using as ENTER button.
10.
(Power)-button: Preparation: Connect power-cable to 230V/50Hz.
a) If standby-LED is red, you may power-off. To power-off, press power-button 1x and release.
For confirmation, standby-LED will turn off.
b) If standby-LED is off, you may power-on. To power-on, press power-button 1x and release.
For confirmation, standby-LED will change to red and about 1 second later to green.
c) If the TV is currently working, press power-button 1x and release to power-off.
For confirmation, standby-LED will turn off.
In power-off-condition, the unit cannot be power-on by pressing
In power-off-condition, the TV's power-consumption is approx. 1 Watt.
If total disconnection from the mains is required, please unplug.
6
51K0201A_ENG.indd 6
All manuals and user guides at all-guides.com
9/12/08 4:54:21 PM
3
1
2
to change to a higher numbered channel set into
to change to a lower numbered channel set into
on the remote control.
9/12/08 4:54:24 PM
Where to install
Locate the television away from direct sunlight and
strong lights, soft, indirect lighting is recommended
for comfortable viewing. Use curtains or blinds to
prevent direct sunlight falling on the screen.
Place on a sturdy platform, the mounting surface
should be flat and steady. It should then be secured
to the wall with a sturdy tie using the clip on the
back of the stand, or secured to the platform using
the fixing strap located underneath the table top
stand, this will prevent it from falling over.
The LCD display panels are manufactured using
an extremely high level of precision technology,
however sometimes some parts of the screen may
be missing picture elements or have luminous
spots. This is not a sign of a malfunction.
Make sure the television is located in a position where it cannot be pushed or hit by objects, as pressure will
break or damage the screen, and that small items cannot be inserted into slots or openings in the case.
Retractable pedestal stand and locating the LCD TV
Observe the following safety precautions:
1) Ensure that unpacking and transfer of the unit is carried out by two or more people.
2) Put the LCD TV on a large level area in a recumbent posture.
3) Grab the pedestal stand and lift the display up. Confirm the pivot is locked.
4) Place the TV on a sturdy, level surface that can support the weight of the TV.
5) Be sure to secure the TV to a wall stud, pillar, surface, or other immovable structure. To
secure the TV in this manner: (1) attach a clip to an immovable structure, then (2) pass
a sturdy strap through the clip and attach each end to the hooks located at the back of
the TV. Be sure to leave at least 10 cm between the TV and the wall or similar structure
for ventilation
.
To fold the pedestal stand
1) Slide the lever on the back side of the pedestal
stand to the left.
2) Lay the display down.
NOTE: Do not operate the LCD TV when the pedestal stand is folded. The pedestal stand should not be
folded at any time except for packing purposes.
Please take note
EXCLUSION CLAUSE
Toshiba shall under no circumstances be liable for loss and/or damage to the product caused by:
i)
fire;
ii)
earthquake;
iii) accidental damage;
iv) intentional misuse of the product;
v)
use of the product in improper conditions;
vi) loss and/or damage caused to the product whilst in the possession of a third party;
vii) any damage or loss caused as a result of the owner's failure and/or neglect to follow the instructions
set out in the owner's manual;
viii) any loss or damage caused directly as a result of misuse or malfunction of the product when used
simultaneously with associated equipment;
Furthermore, under no circumstances shall Toshiba be liable for any consequential loss and/or damage
including but not limited to the following, loss of profit, interruption of business, the loss of recorded data
whether caused during normal operation or misuse of the product.
If stationary images generated by text services, channel identification logos, computer displays, video
games, on screen menus, etc. are left on the television screen for any length of time they could become
conspicuous, it is always advisable to reduce both the brightness and contrast settings.
51K0201A_ENG.indd 5
EJECT
TV/DVD
SLEEP
(On/Standby)
0-9
DISPLAY
MUTE
SUBTITLE
INPUT
DVD MENU
TOP MENU
VOL +/–
AUDIO SELECT
CH RTN
ZOOM
/ / /
P (Programme) +/–
ENTER
CH LIST
MENU
SETUP
EXIT
CANCEL
RETURN
PLAY
STOP
SKIP 6
REV 8
FF 9
SKIP 7
SLOW
PAUSE
PLAY MODE
SLOW
Four coloured
buttons (Red,
Green, Yellow,
Blue)
MARKER
ANGLE
REPEAT A-B
JUMP
PIC SIZE
51K0201A_ENG.indd 7
Important safety information
Sturdy tie (as short as possible)
Clip
Hooks
Screw
hole
Screw
Band
Side View
Top View
Slide the lever to the left
Back side of the pedestal stand
9/12/08 4:54:22 PM
Remote Control
PAGE
Eject a disc
21
Select to operate TV or DVD
11, 20
Sleep Timer
14
Enter standby mode or turn on the power
10
Direct channel selection of TV
14
Input setting
23, 34
Enter a security code
39
Display TV or DVD operation status
14, 27
Mute
14
Set the Subtitle of a DVD disc
27
Select an input source
11
Select menu of a DVD disc
26
Display JPEG thumbnail list
30
Select title of a DVD disc
26
Return to JPEG file browser
30
Volume Up/Down
14
Change sound track language of DVD/VCD
16, 27
Channel return
14
Zoom
23
Hold (Teletext)
15
Teletext on/off
15
Cursor buttons
10
Select channel of the TV
14
Enter information in the menu/ Select option in the menu
10, 35
Display the channel list
14
Display menu of setup
11
35
Exit the menu screen
11
Cancel input data in the setting mode
23, 24, 34, 38
Remove DVD setup menu
35
Playback
20
Stop
20
Skip chapter/track to reverse direction
22
Reverse search playback
22
Reveal (Teletext)
15
Forward search playback
22
Sub page (Teletext)
15
Skip chapter/track to forward direction
22
Select text position when viewing Teletext
15
Slow motion playback to reverse direction
22
Still picture
21
Select playback mode
19, 25, 34
Slow motion playback to forward direction
22
Access the Teletext
15
Index for DVD/VCD/Audio CD
24
Change playback angle of a DVD disc
26
Rotate JPEG picture
30
Repeat playback between A and B
25
Locating desired scene
23
Select picture format
17
9/12/08 4:54:27 PM
5
7
Advertisement
Table of Contents
Troubleshooting
