Turning The Phone On/Off; Inserting Sim, Memory Card And The Battery - mPTech myPhone Rumba 2 Quick Start Manual

EN © mPTech 2020. All rights reserved.
Volume
15
buttons
16
17 Contacts
MicroUSB
18
19
Headphone
20
port minijack
3.5 mm

Turning the phone on/off

To turn the phone on/off press and hold the Red handset button.
If directly after turning the phone on you will see a PIN code
request, (in form of "****") type the code and press Menu button

Inserting SIM, memory card and the battery

If the phone is switched on - switch it off. Remove the back cover
of the phone - use your fingernail to raise it using the gap in the
case. Insert the SIM card - It is supposed to be placed with its gold
contacts facing down, the way in which the slot is embossed.
Insert the memory card - to open the cover of the card reader
slide it gently up. Insert the microSD memory card with its gold
contacts facing down, the way in which the slot is embossed.
They are designed to change the
volume of the media and during the
call. When held down the volume up
button turns the flashlight on or off
LED Diode is used as a torch.
Allow you to connect your phone to
the charging base.
When
enables recharging the battery. You
can transfer data (photos, videos,
port
music) when you connect it to your
computer.
Allows to take off a cover of the
Gap
phone.
It allows you to connect headphones
to your phone, so you can listen to
the radio (improve the quality of
reception - act as an additional
antenna), music, and also make calls
(when headphones are equipped
with a microphone).
connected,
20
Rumba 2
the charger