Supero CSE-PTJBOD-CB3 User Manual page 17

3-2 SC847 JBOD
SAS3 I
Use the diagram below to connect the CSE-PTJBOD-CB3 to the front and rear
backplanes in the SC847 JBOD chassis.
Jumper
JP5
When enabling SAS2/SAS3 functionality, use connectors JP1-JP4, (see Page 2-4)
and set the JP5 jumper to pins 1-2 (SAS3) or pins 3-4 (SAS2).
When an SC847D chassis is being used, use connectors J4-J7 (see Page 2-4) and
set the JP5 jumper to pins 2-3.
JP1
JP3
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
Chapter 3 Connecting to the Front and Rear Backplanes
Cabling
C Cabling in the SC847 JBOD Chassis
2
Pins 1-2: SAS3 enabled
Pins 2-3: SAS2 enabled and SC847D
CBL-CDAT-0601
CBL-CDAT-0601
CSE-PTJBOD-CB3
Figure 3-3: SAS3 I C Cabling in the SC847 JBOD Chassis
2
Jumper Settings
Setting
Front Backplane BPN-SAS3-
846EL1/EL2 Connected to the
Rear Backplane
BPN-SAS3-847EL1/EL2
Connected to the Primary I
Connector (SMB)
3-3
I C Connector (I2C0)
2
C
2