Setup - Hoshizaki KM-520MAJ-E Instruction Manual
Modular crescent cuber
Hide thumbs
Also See for KM-520MAJ-E:
- Instruction manual (46 pages) ,
- Installation manual (39 pages) ,
- Service manual (47 pages)
Table of Contents
Advertisement
D. Setup
1. Dispenser Unit/Ice Storage Bin and Icemaker Setup
• The installer must ensure the dispenser unit/ice storage bin is compatible with
the icemaker, and the dispenser unit/ice storage bin and icemaker are properly
attached and secured.
• Do not allow top kits to interfere with the bin control lens sensing area or the
icemaker will not operate properly.
1) If mounting the icemaker on top of a dispenser unit, follow the dispenser unit's setup
procedure. If mounting the icemaker on top of an ice storage bin, unpack the ice storage
bin and attach the 4 adjustable legs provided (bin accessory) to the bottom of the ice
storage bin.
2) Position the dispenser unit/ice storage bin in its permanent location.
3) If required, install an adapter kit or top kit. Contact your local Hoshizaki distributor for
recommendations.
4) Level the dispenser unit/ice storage bin in both the left-to-right and front-to-rear
directions. If using an ice storage bin, adjust the ice storage bin legs to level.
5) Place the icemaker on top of the dispenser unit/ice storage bin.
6a) Dispenser Unit: Follow the dispenser unit, adapter kit, or top kit instructions for
securing the icemaker. If no instructions are available, secure the icemaker using the
mounting brackets provided. Rotate the mounting brackets so that they fit flush to the
dispenser unit. See Fig. 2a. Secure the mounting brackets to the icemaker with the bolts
provided. Secure the mounting brackets to the dispenser unit with self-tapping screws
(not provided). NOTICE! Use care to avoid damage to dispenser unit components
when attaching the mounting brackets. For dispenser unit bin control setting see
"II.H.1. Bin Control Setting."
6b) Ice Storage Bin: Follow the ice storage bin, adapter kit, or top kit instructions for
securing the icemaker. If no instructions are available, secure the icemaker using the
2 mounting brackets and the bolts provided. See Fig. 2b.
Mounting
Brackets
Bolts
Fig. 2a
Self-Tapping
Screws
(Not Provided)
WARNING
Icemaker
Dispenser
Unit
Fig. 2b
Ice
Storage
Bin
10
Icemaker
Bolts
Mounting
Brackets
- Quick Links:
- Bin Control Setting
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the KM-520MAJ-E and is the answer not in the manual?
Questions and answers
I bought a new Hoshizaki Km-520. I disconnected my old one and connected the new one the same way. When I powered it up it just beeps once and doesn’t do anything. Do I need to program anything?
If your Hoshizaki KM-520MAJ-E beeps once and does not power on after installation, confirm that the control switch is in the "ON" position and that the mode switch is set correctly. Also, check the electrical connection and ensure the unit is properly plugged in. If the issue persists, it may indicate a safety condition or installation error. Only a qualified service technician should perform further diagnosis or service.
This answer is automatically generated
@Mr. Anderson - do you know of a Qualified Tech in San Antonio, Texas?