Morplan PRO-STEAM 2 Quick Start Manual

CARE OF YOUR PRO-STEAM 2
To ensure a long, trouble free life it is essential that your steamer is flushed out at least
once a week. Failure to do this will result in damage and will void the warranty.
To flush out your steamer, carefully follow the instructions below:
• Before starting, the water in your steamer must be allowed to cool to a temperature which
will not cause injury before it is tipped out. Disconnect the steamer from the power supply,
then remove the pole set. The hose must be removed and carefully emptied of any water
• Where possible, your steamer should be emptied into a ground level drain - NOT lifted up
and emptied into a sink
• Refill the steamer with fresh tap water and empty again. Do not use any additives such as
perfume which will void the warranty. Repeat this procedure until the water pours out clear.
Finally, wipe the casing with a damp cloth or a duster and polish
• Persons using the steamer must be authorised to do so. They must be trained in safe
working procedures; and when necessary protective clothing should be worn
• Service should only be carried out by Morplan or an approved service agent
Pro-Steam 2 - One Year Guarantee
Your Pro-Steam 2 steamer is guaranteed against defects in material or
workmanship for 1 year commencing on the date of purchase. Under
normal use, if any part proves to be defective, the steamer will be
repaired free of charge within 12 months from the date of purchase.
This guarantee does not apply to any unit which has been subject to
misuse, negligence, accident or natural calamities or without proof of
purchase. Failure of the steamer due to build up of lime scale is not
covered. You must take the necessary steps to protect your steamer from
harmful hard water problems. Cables are excluded from the guarantee.
Dealing with Hard Water
Before using your steamer, use
the Hard Water Test Strip supplied
and enter your test result right
● Serial Number:
Rated Voltage: 230v 50Hz AC only
●
THIS APPLIANCE MUST BE EARTHED
● Wattage: 1500w
● Water Capacity: 2 Litres
For Service and Repair, telephone 01279 453 333
or return the steamer to the address below
Morplan Ltd, PO Box 54, Harlow, Essex, CM20 2TS
Freefone 0800 435 333
Freefax 0800 451 928
www.morplan.com
PPM
Drapery Accessories
for Pro-Steam Steamers
This picture shows a Pro-Steam 2
fitted with a Drapery Kit 471 18
The Kit includes a 3m (9' 10")
hose and a set of high reach poles
PRO-
PRO-
STEAM
STEAM
Order Code 470 93
Can be used
by anyone to
achieve a
perfect finish.
It will remove
even the worst
wrinkles and
creases
2
2