ERICO CADDY TSGB Series Instruction Sheet

INSTRUCTION SHEET


TSGB16 & TSGB24
Field assembled
Separate
Bracket ready to attach to wall studs.

WARNING:

1. ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials.
sheets are available at www.erico.com and from your ERICO customer service representative.
2. ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that
exceeds specified load ratings.
3. All instructions must be completely followed to ensure proper and safe installation and performance.
4. Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause
product malfunction, property damage, serious bodily injury and death.
5. Products that are manufactured using spring steel components shall be used only in a non-corrosive indoor environment.
6. All pipe supports, hangers, intermediate components and structural attachments must ONLY be used as described herein and are
NEVER to be used for any other purpose.
NOTE: All load ratings are for static conditions and do not account for dynamic loading such as wind, water or seismic loads,
unless otherwise noted.
The customer is responsible for:
a. Conformance to all governing codes.
b. The integrity of structures to which the products are attached, including their capability of safely accepting the loads
imposed, as evaluated by a qualified engineer.
c. Using appropriate industry standard hardware as noted above.

SAFETY INSTRUCTIONS:

All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as
appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
TECHNICAL SUPPORT:
www.erico.com
PART NO
TSGB 16*
TSGB16ASY*
TSGB24*
TSGB24ASY*
*KEYHOLES ARE ON TSGB16 ONLY
Assemble
Use screw gun to assemble to stud.
Only one mounting screw required
at each end of bracket.
CFS300_D 1 OF 2 © 2009 ERICO International Corporation
DESCRIPTION STUD SPACING
ADJUSTABLE 11" TO 18"
ADJUSTABLE
11" TO 18"
PRE-ASSEMBLED
ADJUSTABLE 17" TO 26"
ADJUSTABLE
17" TO 26"
PRE-ASSEMBLED
TSGB16ASY & TSGB24ASY
Pre-assembled
Adjust to box
Attach electrical boxes.
Instruction
BOX DEPTH
1-1/2" OR 2-1/8"
1-1/2" OR 2-1/8"
1-1/2" OR 2-1/8"
1-1/2" OR 2-1/8"