CREE LIGHTING Traveyo Series Installation Instructions Manual

IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be
followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l'alimentation avant l'installation.
2. This luminaire must be installed in accordance with the NEC or your local
electrical code. If you are not familiar with these codes and requirements,
consult a qualified electrician.
Ce produit doit être installé conformément à NEC ou votre code électrique
local. Si vous n'êtes pas familier avec ces codes et ces exigences, veuillez
contacter un électricien qualifié.
3. If NEMA photo control is installed refer to NEMA
®
instructions.
4. If mounting bolts are completely removed in the field they should be hand
threaded (prior to use of power tools) to ensure proper engagement of the
thread when re-installing. Failure to pre-start threads may result in
cross-threading or stripping of the bolts during reinstallation.
SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE
TO INSTALL:
Mounting
Adjustment
1
Bracket
Steps
Mounting Bracket Bolts
LUMINAIRE INSTALLATION
STEP 1:
Slide fixture on to a minimum 8" long tenon,
through opening on the rear of housing. See
Figure 1.
STEP 2:
Once desired position is achieved, open cover
by holding fixture and loosen the captive
D-ring and allow the cover to swing open. See
Figure 2 and 3.
NOTE Maximum assembly torque value for
D-ring installation is 45 in-lbs (5 N·m).
1 of 7
Receptacle section for
®
2
D-ring
STEP 3:
To level fixture, use bubble level located
inside housing. Adjust leveling of fixture from
side to side by rotating fixture on tenon. To
level from front to back, slide pole in or out
to different step in upper housing. Each step
changes the angle in 2.5° increments
STEP 4:
NOTE: When tightening bolts make sure
to alternate between bolts to keep bracket
straight.
Traveyo Series
NOM LED Street and Area Light
Includes: TRVSM, TRVMD, TRVLG and TRVXL
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D'INSTALLATION
• Prior to installation, store luminaire in a dry location
protected from rain, dust, and outdoor environment.
If equipped with a photocell receptacle, do not store
or install luminaire outdoors without immediately
installing a suitable photocell, shorting cap, or other
compatible device. Do NOT leave receptacle open to
environmental elements. Luminaires with a top-
mounted photocell receptacle should not be installed in
an up-light position or at a tilt greater than 45 degrees
from the down-light position.
• This product must be installed in accordance with the
applicable installation code by a person familiar with
the construction and operation of the product and the
hazards involved.
Importer: IDEAL PRODUCTS DISTRIBUTION DE MEXICO S.
DE R.L. DE C.V.
Address: Paseo de los Adobes, 1079, no. 10, Colonia
Guadalajara Technology Park, C.P. 45010
3
NOTE: TRVLG and TRVXL luminaires ordered
with 4BLT option will have (2) mounting
brackets and (4) mounting bolts.
Tighten mounting bolts to the appropriate
torque values specified in TORQUE VALUES
table on page 2. See Figure 1 (use 9/16"
socket wrench).
STEP 5:
Reference Electrical Connections section for
completing electrical connections.
LPN00620X0002A1_B