Horizon Hobby Spektrum SLT2 Manual

Horizon Hobby Spektrum SLT2 Manual

2ch 2.4ghz transmitter

Advertisement

Quick Links

SLT2 2CH 2.4GHz Transmitter manual

Product specification

Model number:SPMSLT200F(SLT2 2CH TX);
PMN:SPMSLT200
Power supply:4.0V~6.6V;
Working frequency:2.4G;
Transmitted power:<40mW;
Control distance:>100meters;
Battery:4*AA;
Adjust method: Knob adjust & Switch adjust.
Operating temperature:-10~55℃

Main function

2CH transmitter, It can adjust steering(CH1/ST) TRIM、DR、REV、
EPA. Can adjust throttle(CH2/TH) DR、EPA.
Low battery voltage alarm.
Please strictly follow the supply voltage mentioned in the manual. Excessive
supply voltage may cause the equipment to burn.
Transmitter battery is suitable for 4 alkaline batteries, ensure that the
positive and negative batteries are installed correct, incorrect battery polarity
will cause damage to the transmitter! The transmitter uses red LED to indicate
the battery power. When the red LED blinks from steady on to slow, it means
the battery power is low. Please replace the battery in time!

Warning

Transmitter

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Spektrum SLT2 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Horizon Hobby Spektrum SLT2

  • Page 1 SLT2 2CH 2.4GHz Transmitter manual Product specification • Model number:SPMSLT200F(SLT2 2CH TX); • PMN:SPMSLT200 • Power supply:4.0V~6.6V; • Working frequency:2.4G; • Transmitted power:<40mW; • Control distance:>100meters; • Battery:4*AA; • Adjust method: Knob adjust & Switch adjust. • Operating temperature:-10~55℃ Main function •...
  • Page 2 Install battery Transmitter battery is suitable for 4pcs 1.5V AA alkaline batteries, Install the battery according to the mark in the battery box. Press the battery cover hook in the direction of the arrow, and open the battery cover downward; According to the mark in the battery box, put four AA batteries in turn.
  • Page 3 Transmitter can control throttle (TH/CH2). You can pull throttle trigger to backward to control car forward or push throttle trigger to forward to control car backward. ST DR(SR) Transmitter can adjust steering (ST/CH1) travel. You can rotate clockwise ST DR rotary knob to add steering (ST/CH1) to MAX travel, also you can rotate anticlockwise ST DR rotary knob to reduce steering (ST/CH1) to Min travel, range is 20%-100%.
  • Page 4 The setting is as follow: . Step1.turn steering wheel to max right position and push throttle trigger to max forward position, Hold them and push power button to open transmitter. . Step2.transmitter red LED will flash rapidly, It means transmitter enter EPA setting state, release steering wheel and throttle trigger to nature position (middle position).
  • Page 5 Note: Before the transmitter leaves the factory, the throttle and steering neutral point and the max travel have been calibrated OK. Incorrect throttle calibration will cause the motor to be unable to output the full throttle travel or the throttle backward is not linear; Incorrect steering calibration may result in the steering servo not being able to output at full Angle or not being linear at the back of the steering.
  • Page 6 installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver.

This manual is also suitable for:

Spmslt200f

Table of Contents

Save PDF