Installation; Incoming Acceptance, Transport And Storage; Incoming Acceptance; Transport - Endress+Hauser Proline Prosonic Flow 93 PROFIBUS DP/PA Operating Instructions Manual

Proline Prosonic Flow 93 PROFIBUS DP/PA
Endress+Hauser
3

Installation

3.1

Incoming acceptance, transport and storage

3.1.1

Incoming acceptance

On receipt of the goods, check the following points:
• Check the packaging and the contents for damage.
• Check the shipment, make sure nothing is missing and that the scope of supply matches your
order.
3.1.2

Transport

The devices must be transported in the container supplied when transporting them to the measuring
point.
3.1.3

Storage

• Pack the measuring device in such a way as to protect it reliably against impact for storage (and
transportation). The original packaging provides optimum protection.
• The storage temperature corresponds to the ambient temperature range of the transmitter, the
sensors and the corresponding sensor cables (→ ä 158).
• The measuring device must be protected against direct sunlight during storage in order to avoid
unacceptably high surface temperatures.
3.2

Installation conditions

3.2.1

Dimensions

The dimensions and lengths of the sensor and transmitter are provided in the separate "Technical
Information" document on the device in question. This can be downloaded as a PDF file from
www.endress.com.
A list of the "Technical Information" documents available is provided on → ä 162
3.2.2

Mounting location

Correct flow measurement is possible only if a pipe is full. Entrained air or gas bubbles forming in
the pipe can result in an increase in measuring errors.
Avoid the following locations in the pipe installation:
• Highest point of a pipeline. Risk of air accumulating.
• Directly upstream of a free pipe outlet in a vertical pipeline.
Fig. 4: Mounting location
Installation
A0001103
11