Advertisement
6. Trouble shooting
The temporary vibration occurs in the image
With quick acceleration or slow down, the image may temporarily vibrate. This may be avoided by
taking the following actions:
• Decrease STIFFNESS value by 5 to 10.
• Increase HOLD STRENGTH value. Do not set the value higher than 55. If you change the
HOLD STRENGTH value, you need to adjust the STIFNESS value as well.
The image resolution gets lower
If the image quality gets lower while hovering or flying slowly, try the following adjustments:
• Decrease STIFFNESS value by 5 to 10.
• Decrease HOLD STRENGTH value. Do not set the value lower than 40. If you change the
HOLD STRENGTH value, you need to adjust the STIFNESS value as well.
The image is distorted or undulate
With quick acceleration or high-speed flight, image may be distorted or undulate.
This may be avoided by taking the following actions:
• Decrease STIFFNESS value by 5 to 10.
• Decrease HOLD STRENGTH value. Do not set the value lower than 40. If you change the
HOLD STRENGTH value, you need to adjust the STIFNESS value as well.
Airpeak gimbal setting guide
(continued)
I
Manual adjustment of motor parameters
12
Advertisement
