Sealey SLC2 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMP P OR R TA TANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
TH H E P P RO O DUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PE E RS S ON N AL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SAFETY
 WARNING! Due to the variety in the design of vehicles and roof bars/racks, it is the users responsibility to ensure that the ladder
rack clamps are fi tted and attached correctly.
 DO NOT use the ladder rack clamps if any parts are damaged or missing, as this may cause failure and/or possible personal injury.
 Maintain the ladder rack clamps in good condition.
 Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
Familiarise yourself with the applications and limitations of the ladder rack clamps, as well as all potential hazards.

 DO NOT use the ladder rack clamps for any purpose other than that for which it is designed.
 Always use the ladder rack clamps in pairs. One at the front and one at the rear.
 During use frequently check that the ladder rack clamps and ladder are secure.
 DO NOT over tighten the ladder rack clamps. This may cause damage to the roof bar/rack or the clamps.
 Use only to clamp ladders.
 WARNING! Remove any loose objects from the ladder prior to clamping to the roof bar/rack.
 WARNING! Ensure that neither the ladder rack clamps or the ladder project beyond the maximum profi le of the vehicle.
 WARNING! When a ladder is clamped to the roof bars/rack, the characteristics of the vehicle will change. Driving techniques
should be altered to allow for this. Reduce speeds and allow longer braking distances.
 Check that the ladder is secure and stable prior to transit.
WARNING! The security and safety of the load carried is the responsibility of the vehicle driver.

 WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations
that may occur. It must be understood by the operator that common sense and caution are factors which cannot
be built into this product, but must be applied by the operator.
2. INTRODUCTION
Universal fi tment for roof racks providing a safe and easy way to secure ladders. Yellow phosphate fi nish for added corrosion resistance.
Suitable for trades where ladders need to be transported safely for on site applications. Supplied with two heavy-duty iron padlocks for
security. Made in the UK.
3. SPECIFICATION
Model No: ..................................................................... SLC2
Maximum width: ......................................................... 365mm
4. CONTENTS
ITEM DESCRIPTION
1 Roof bar hooks
2 Clamp bar
3 Ladder stop
4 Washer
5 Lock bar
6 Thread protector
7 Padlock (not shown)
© Jack Sealey Limited
LADDER ROOF RACK CLAMPS
SLC2
MODEL NO:
QTY
1
1
2
1
1
1
1
Original Language Version SLC2 Issue 2 (H,F) 08/11/21