Engine - Yamaha EF3000iS Owner's Manual

5
6. Drain the fuel remaining in the carburetor into an
5 Drain screw
7. Tighten the drain screw.
707-102c
8. Turn the engine switch to "5" (STOP).
9. Turn the fuel cock lever to OFF.
10. Install the cover and tighten the screw.
11. Tighten further if any screws, bolts and nuts are
12. Store the generator in a dry, well-ventilated place,

Engine

Perform the following steps to protect the cylinder, pis-
ton ring, etc. from corrosion.
1. Remove the spark plug, pour about one table-
2. Pull the recoil starter until you feel compression.
3. Clean exterior of the generator and apply a rust
4. Store the generator in a dry, well-ventilated place,
712-028a
5. The generator must remain in a vertical position
6. The caster lock lever should be in the LOCK posi-
712-029b
approved container by loosening the drain screw
on the carburetor float chamber.
loose.
with the cover placed over it.
spoon of engine oil (See page 33) into the spark
plug hole and install the spark plug only. Recoil
start the engine by turning over several times (with
ignition off) to coat the cylinder walls with oil.
Then stop pulling. (This prevents the cylinder and
valves from rusting).
inhibitor.
with the cover placed over it.
when stored, carried or operated.
tion when stored or operated.
– 43 –